15LS Dotco Drill - Parts

This is an authentic manufacturer-approved replacement o-ring which is specially designed for use with Dotco and Cleco power tools. It helps to provide an air-tight seal between connected pieces, please make sure to check appropriate diagrams of your model for the correct location and use of this hardware. This high-quality o-ring is made...Read more of durable rubber and it is sold individually, over time the material may wear out and crack eventually requiring a replacement.

This part is available as an individual replacement. The push rod attaches to the motor housing. A set of pliers might be helpful during the installation of this item. It is made of metal and will need to be replaced if it breaks. This is an OEM replacement part for use in grinders, sanders, saws, buffers, and drills made by Cleco and Dotco.

This ball bearing is an original part from the Cleco manufacturer. Composed of metal, the ball bearing has been made for use with various devices. This part has been designed to reduce engine friction with the use of metal rollers and a surface for them to rotate against. These balls or rollers "bear" the load, allowing the device to spin...Read more smoothly. This part is sold individually. A wrench and a screwdriver are often needed to make the necessary replacement. Please refer to the specific manual for repair instructions.

This authentic manufacturer-sourced component is specially designed for Cleco and Dotco tools. It is an identical replacement for a missing or a faulty hardware that was installed on a new unit. Check the appropriate diagrams for your model for the exact location and the correct application of this pin. Keep in mind this high-quality comp...Read moreonent is made of durable metal and is sold individually. Pliers might be needed to secure or remove it.

The valve spring attaches to the valve and is made of metal. It is an authentic OEM sourced item which is specially produced for use with grinders, sanders, buffers, and saws made by Dotco and Cleco. This item is available as an individual replacement part. When replacing this part a wrench might be required during the installation process. It will need to be replaced if it becomes broken.

This part is an OEM from the Dotco manufacturer. Made of durable plastic, the twelve point housing wrench is compatible with many bufflers, grinders and drills. This item is often used to hold housings like a vice when replacing related components in the system. This part is sold individually.

This is an authentic manufacturer-approved replacement o-ring which is specially designed for use with Dotco power tools. It helps to provide an air-tight seal between connected pieces, lease make sure to refer to the appropriate diagrams of your model for the correct location and use of this hardware. It is made of high-quality rubber material and it is sold individually.

This is an authentic OEM part. The Dotco output spindle is constructed of metal, and is designed for use with several angle drill devices. This item often helps to secure the drill chuck to the angle drill. It is recommended to review the specific manual and diagrams for repair instructions. This component is sold individually. A hex wrench is needed in making the replacement.

This is a genuine replacement part sourced directly from the manufacturer. The ball bearing is commonly found in Dotco angle drills. This part is made of metal, and is placed to allow the spindle extension to spin freely. Please be aware that there are different ball bearings used in the machine. Refer to the parts diagram to be sure ...Read moreof ordering the correct part. It is advisable when removing multiple parts to keep careful track of their order so they can be reassembled correctly. This item is sold individually.