15LF Dotco Drill - Parts

This is an authentic manufacturer-approved replacement o-ring which is specially designed for use with Dotco and Cleco power tools. It helps to provide an air-tight seal between connected pieces, please make sure to check appropriate diagrams of your model for the correct location and use of this hardware. This high-quality o-ring is made...Read more of durable rubber and it is sold individually, over time the material may wear out and crack eventually requiring a replacement.

This ball bearing is an original part from the Cleco manufacturer. Composed of metal, the ball bearing has been made for use with various devices. This part has been designed to reduce engine friction with the use of metal rollers and a surface for them to rotate against. These balls or rollers "bear" the load, allowing the device to spin...Read more smoothly. This part is sold individually. A wrench and a screwdriver are often needed to make the necessary replacement. Please refer to the specific manual for repair instructions.

It is a genuine item that is supplied by the original equipment manufacturer for use with Cleco and Dotco vanes, shavers, drills, scissors, and grinders. The rotor blade attaches to the rotor and a set of pliers, a wrench set, and a screwdriver may all be needed during the replacement process. This part is made of metal and is priced individually even though four may be needed.

This authentic manufacturer-sourced component is specially designed for Cleco and Dotco tools. It is an identical replacement for a missing or a faulty hardware that was installed on a new unit. Check the appropriate diagrams for your model for the exact location and the correct application of this pin. Keep in mind this high-quality comp...Read moreonent is made of durable metal and is sold individually. Pliers might be needed to secure or remove it.

It is a genuine component that is supplied directly from the original equipment manufacturer for use with Dotco equipment. This part provides an identical replacement for a missing or a faulty push rod that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and applica...Read moretion of this component. Keep in mind this high-quality push rod is made of durable metal and is sold individually.

The valve spring attaches to the valve and is made of metal. It is an authentic OEM sourced item which is specially produced for use with grinders, sanders, buffers, and saws made by Dotco and Cleco. This item is available as an individual replacement part. When replacing this part a wrench might be required during the installation process. It will need to be replaced if it becomes broken.

This authentic replacement part is designed for use with Dotco and Cleco equipment. The rollers take the load and spin, distributing the weight evenly while the minimal contact area reduces friction. It is made of high-quality metal and is sold individually. You will need a screwdriver and a wrench set to take apart and reassemble the hou...Read moresing when performing this repair. Make sure to check the diagrams for your model to ensure the correct replacement procedure.