143996501 Craftsman Engine - Parts

This item is available as an individual replacement part. The gasket attaches to the intake pipe and is made out of a thin material. During replacement, it may require a screwdriver to help install this part correctly. It will require replacing if it breaks. This genuine item is supplied by the original equipment manufacturer for use with...Read more lawn mowers, lawn tractors, and snowblowers made by Tecumseh, Toro, and Lawn Boy.

This is a genuine replacement part that has been sourced from the original manufacturer to be used with snow thrower engines from Husqvarna and Toro. The metal screw is used to fasten the fuel tank to the tank mounting bracket. This item is available as an individual replacement part, please note a hex socket wrench may be needed to install this item.

This piston ring set is designed to create a tight seal between the piston and cylinder wall, helping restore proper compression and reduce oil consumption in small engines. By improving sealing efficiency, it supports smoother starting, steady power, and reliable overall performance. Ideal for replacing worn or damaged rings, it helps extend engine life and maintain consistent operation.

This is a genuine replacement part sourced from the original manufacturer for use with small engines. The metal hex nut is used to fasten the engine's flywheel to the crankshaft assembly. This item is available as an individual replacement part, please see diagram for related items.

This spark plug cover is supplied directly from the original equipment manufacturer. The rubber and metal component is often used in snowthrower engines, and is sold individually. The spark plug cover is fitted over the spark plug wire connection, providing protection. A screwdriver and pliers may be required for the removal and replacement.

This is an authentic part that is supplied directly from the original equipment manufacturer for Craftsman and Tecumseh pressure washers, lawn mowers, and snow blowers. When pulled, the starter rope engages starter spring causing the engine turn fast enough for the ignition module to generate a spark to ignite the fuel in the cylinder. Th...Read moreis part is made of nylon rope and is sold individually. To install the rope you will need a screwdriver and socket wrench. Turn the starter spring to build tension and recoil the rope inside.

This O-ring is designed for use with small engine carburetors and is made of rubber, meaning over time and further exposure to fuel, it will become brittle and crack. This O-ring is installed within the carburetor and is located between securing screws near the base. If disassembling your equipment to replace this O-ring, it is recommende...Read mored you inspect the other parts to ensure optimal performance and to prevent any leaks. Featuring an inner-diameter of approximately 0.25-inches, the replacement process for this O-ring in your engine will vary, so check the user manual for exact location of this part.