14308 - Parts

This part is available as an individual replacement. The extension spring attaches to the control. A screwdriver and a set of pliers might be needed during the installation process. This part is made out of metal and will need to be replaced if it bends or breaks. It is a genuine item that is supplied by the original equipment manufacture...Read morer for use with engines and snowblowers made by Tecumseh, Husqvarna, Toro, and Lawn Boy.

This is a genuine replacement part sourced from the original manufacturer for use with small engines. The metal hex nut is used to fasten the engine's flywheel to the crankshaft assembly. This item is available as an individual replacement part, please see diagram for related items.

This spark plug cover is supplied directly from the original equipment manufacturer. The rubber and metal component is often used in snowthrower engines, and is sold individually. The spark plug cover is fitted over the spark plug wire connection, providing protection. A screwdriver and pliers may be required for the removal and replacement.

This is an original replacement part manufactured for use with small engines. This special fuel fitting is used to connect the fuel line to the carburetor. Overtime old fuel can clog passageways within the carburetor and may require the carburetor to be rebuilt. This fuel fitting is sold as an individual replacement part, please see model diagram for associative parts.

This is an authentic part that is supplied directly from the original equipment manufacturer for Craftsman and Tecumseh pressure washers, lawn mowers, and snow blowers. When pulled, the starter rope engages starter spring causing the engine turn fast enough for the ignition module to generate a spark to ignite the fuel in the cylinder. Th...Read moreis part is made of nylon rope and is sold individually. To install the rope you will need a screwdriver and socket wrench. Turn the starter spring to build tension and recoil the rope inside.

This O-ring is designed for use with small engine carburetors and is made of rubber, meaning over time and further exposure to fuel, it will become brittle and crack. This O-ring is installed within the carburetor and is located between securing screws near the base. If disassembling your equipment to replace this O-ring, it is recommende...Read mored you inspect the other parts to ensure optimal performance and to prevent any leaks. Featuring an inner-diameter of approximately 0.25-inches, the replacement process for this O-ring in your engine will vary, so check the user manual for exact location of this part.

This authentic part is supplied by the original equipment manufacturer for Tecumseh engines commonly installed on Toro lawn and garden equipment. The float is used to allow fuel into the float chamber when the chamber has been drained and to stop fuel from entering the chamber when it is full. It provides an identical replacement for a mi...Read moressing or a faulty component that was installed on a new unit. Refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality float is made of durable plastic and is sold individually.

It is a genuine manufacturer-approved replacement part that is supplied for use with Tecumseh engines commonly installed on Toro and Husqvarna snowthrowers. This is the special screw which is used to secure the carburetor cover which protects the internal components from dust and other debris. It is a high-quality hardware which is made of durable metal and it is sold individually.