143009001 Craftsman Engine - Parts

This is a genuine replacement part that has been sourced from the original manufacturer to be used with snow thrower engines from Husqvarna and Toro. The metal screw is used to fasten the fuel tank to the tank mounting bracket. This item is available as an individual replacement part, please note a hex socket wrench may be needed to install this item.

This plug is an OEM direct from Craftsman for lawn mowers, tillers, lawn tractors, and chippers/shredders. This plug produces the flare that starts up the fuel in the engine. You will need a deep socket and a wrench to replace this part. This plug is made of plastic and metal. This part is sold individually.

This OEM valve cover gasket, also known as the breather gasket, creates a seal between the breather body and cylinder block in your lawn equipment. Made of flexible plastic, it measures 2 inches by 4 inches. Oil stains or leaks around the valve cover indicate a problem with the gasket. You may also notice a burning smell or ticking noise ...Read morefrom the engine. If the gasket is not replaced, it can lead to severe engine damage and even engine failure. When replacing the gasket, start by turning off your machine and disconnecting the spark plug. Depending on your equipment model and make, you may need to remove components like the air filter or spark plug wires to access the valve cover. Refer to your user manual for guidance. Once you have access to the valve cover, use a wrench or socket to unthread the securing bolts or screws. Then, carefully peel off the old gasket. Please keep in mind that this replacement part is sold individually.

This spark plug cover is supplied directly from the original equipment manufacturer. The rubber and metal component is often used in snowthrower engines, and is sold individually. The spark plug cover is fitted over the spark plug wire connection, providing protection. A screwdriver and pliers may be required for the removal and replacement.

This is an authentic part that is supplied directly from the original equipment manufacturer for Craftsman and Tecumseh pressure washers, lawn mowers, and snow blowers. When pulled, the starter rope engages starter spring causing the engine turn fast enough for the ignition module to generate a spark to ignite the fuel in the cylinder. Th...Read moreis part is made of nylon rope and is sold individually. To install the rope you will need a screwdriver and socket wrench. Turn the starter spring to build tension and recoil the rope inside.

This O-ring is designed for use with small engine carburetors and is made of rubber, meaning over time and further exposure to fuel, it will become brittle and crack. This O-ring is installed within the carburetor and is located between securing screws near the base. If disassembling your equipment to replace this O-ring, it is recommende...Read mored you inspect the other parts to ensure optimal performance and to prevent any leaks. Featuring an inner-diameter of approximately 0.25-inches, the replacement process for this O-ring in your engine will vary, so check the user manual for exact location of this part.

This breather element is also called an air filter cartridge, cleaner element, or engine filter. It prevents debris from reaching the carburetor of your lawn equipment while allowing clean air to enter. This clean air-fuel mixture is essential for energy production. A broken or clogged breather element can lead to fuel flow issues, errati...Read morec operation, or starting difficulties. Neglecting to replace a damaged breather element can result in engine problems such as poor fuel combustion, reduced power, or engine stalling. To access the breather element, locate its housing on your machine using your instruction manual. Remove any necessary clips or screws with pliers or a screwdriver. You may also need to put oil on this breather element while installing it into your machine, according to instructions given by its manufacturer. This OEM-verified component is sold individually.

This is a genuine replacement part manufactured for use with snowthrower engines. This metal hex head screw is flanged to secure a good fit. The screw is used to secure the carburetor cover on many snowthrower engines, however this is a versatile screw, and may have other applications. The screw is sold individually, please see model diagram for part location, and function.