My Orders
- Home
- 13WN77KS011
- Instructions
13WN77KS011 (2012) Troy-Bilt Lawn Tractor - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Oil Drain Sleeve
8 of 13 people
found this instruction helpful.
-
Laurie from RICHLANDS, NC
- Very Easy
- Less than 15 mins
-
Pliers, Socket set, Wrench (Adjustable), Wrench set
I wish this was longer...it's only about 6", barely enough to have the oil flow past the metal plate of the riding lawnmower. I'm going to figure out a way to make a permanent extension something like this video would be SO much better https://www.youtube.com/watch?v=G9ZVoeqr6R8&t=79s
Was this helpful?
Thank you for voting!
upper transmission belt cracked bad
6 of 7 people
found this instruction helpful.
-
William from TRIANGLE, VA
- Easy
- 30 - 60 mins
-
Pliers, Wrench set
Removed battery, then battery hanger brackets.
Removed the tension spring from under side of seat. That was a little tuff to do. put a long phillips screw driver through transmission pulley.
put a 7/8 box wrench on pulley nut and removed it. took old belt off and installed new one. Reversed order of removal.
Getting the t ... Read more ension spring back into the bracket hole was a little tricky. I used a pair of long needle nose pliers to re install the spring.
cut my yard and I'm a happy camper !!!!!!!!!!!!!!!!!!
Removed the tension spring from under side of seat. That was a little tuff to do. put a long phillips screw driver through transmission pulley.
put a 7/8 box wrench on pulley nut and removed it. took old belt off and installed new one. Reversed order of removal.
Getting the t ... Read more ension spring back into the bracket hole was a little tricky. I used a pair of long needle nose pliers to re install the spring.
cut my yard and I'm a happy camper !!!!!!!!!!!!!!!!!!
Read less
Was this helpful?
Thank you for voting!
Didn't line up very easy
2 of 4 people
found this instruction helpful.
-
michael from eden, NC
- A Bit Difficult
- Less than 15 mins
Put one side in bottom first and you have to slightly twist the lens to get the other clips to pop in.
Was this helpful?
Thank you for voting!
Bent the old one on a stump
2 of 4 people
found this instruction helpful.
-
George from BAY VILLAGE, OH
- Really Easy
- Less than 15 mins
-
Socket set
Removed one 1/2" bolt to remove old part .
Slipped new part in place. put bolt in open loop and tightened.
Slipped new part in place. put bolt in open loop and tightened.
Was this helpful?
Thank you for voting!
light switch broken
2 of 7 people
found this instruction helpful.
-
GINO from MURRAY, KY
- Really Easy
- 30 - 60 mins
-
Pliers, Screw drivers, Wrench (Adjustable)
Had to pull stove out of the way for easier replacement of the hood switch. Exact replacement part was simple to change.
Was this helpful?
Thank you for voting!
Blade got bend after hit a stump so had to buy new spindle shaft
6 of 27 people
found this instruction helpful.
-
Randall from GALLIPOLIS, OH
- Very Easy
- Less than 15 mins
-
Socket set
The repair was a very easy.
Was this helpful?
Thank you for voting!