My Orders
- Home
- 13AM77LS058
- Instructions
13AM77LS058 (2012) Murray Lawn Tractor - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
1 deck belt cover fell off and the other rusted and loosening
9 of 11 people
found this instruction helpful.
-
J. Alonzo from TULALIP, WA
- Very Easy
- 15 - 30 mins
-
Socket set
Removed the retaining screws on both belt covers and replaced them with the new ones i purchased.
Was this helpful?
Thank you for voting!
Belt guards broken
7 of 8 people
found this instruction helpful.
-
Jerry from GRAND BAY, AL
- Very Easy
- Less than 15 mins
-
Wrench (Adjustable)
Replaced belt guards. Bended in center plates to keep the belts from slipping off. Works like a charm
Was this helpful?
Thank you for voting!
Oil Drain Sleeve
8 of 13 people
found this instruction helpful.
-
Laurie from RICHLANDS, NC
- Very Easy
- Less than 15 mins
-
Pliers, Socket set, Wrench (Adjustable), Wrench set
I wish this was longer...it's only about 6", barely enough to have the oil flow past the metal plate of the riding lawnmower. I'm going to figure out a way to make a permanent extension something like this video would be SO much better https://www.youtube.com/watch?v=G9ZVoeqr6R8&t=79s
Was this helpful?
Thank you for voting!
Bent the old one on a stump
2 of 4 people
found this instruction helpful.
-
George from BAY VILLAGE, OH
- Really Easy
- Less than 15 mins
-
Socket set
Removed one 1/2" bolt to remove old part .
Slipped new part in place. put bolt in open loop and tightened.
Slipped new part in place. put bolt in open loop and tightened.
Was this helpful?
Thank you for voting!
Mixer began to make a noise on speed two and higher
8 of 31 people
found this instruction helpful.
-
LISA M from BATESVILLE, AR
- Really Easy
- Less than 15 mins
We took our 30 plus year mixer apart. I removed the old grease. There was some crumbly looking grease in the main housing gear section where the nylon gear is located. It looked like it had flour mixed in it. Not certain. Removed as best possible all old grease and applied 6 oz. of new Benalene grease to all of the gears. Now it do
... Read more
es not make the slight howl sound.
Read less
Was this helpful?
Thank you for voting!
Blade got bend after hit a stump so had to buy new spindle shaft
6 of 27 people
found this instruction helpful.
-
Randall from GALLIPOLIS, OH
- Very Easy
- Less than 15 mins
-
Socket set
The repair was a very easy.
Was this helpful?
Thank you for voting!