My Orders
137212 - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
5 HP Briggs and Stratton chipper shredder - no spark
19 of 26 people
found this instruction helpful.
-
Thomas from ALFRED, ME
- Difficult
- 30 - 60 mins
-
Nutdriver, Pliers
Removed old sparkless magneto, replaced with new part PS9278124 Magneto, and still no spark. The only conclusion that I can draw, is this magneto is defective,
Was this helpful?
Thank you for voting!
no gas to carb
14 of 23 people
found this instruction helpful.
-
Dennis from MUKWONAGO, WI
- Really Easy
- 15 - 30 mins
-
Nutdriver
pulled off fuel pump cover ,cleaned surfaces. Applied gasket sealer and replaced fuel pump diaphragm.
Was this helpful?
Thank you for voting!
Old diaphragm dried up
6 of 9 people
found this instruction helpful.
-
Steven C from CENTREVILLE, MI
- A Bit Difficult
- 1- 2 hours
-
Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
Tore carburetor off leaf blower and replaced. To do that require taking off the air cleaner removing the gas tank and all the brackets holding the controls on it. And keeping track of all the screws and Wires that control choke and throttle. I took several photographs. I did not need all the gaskets and jet’s that were included in the ki
... Read more
t but it had what I needed.
Read less
Was this helpful?
Thank you for voting!
Generator would not start, Birggs & Stratton recommended to replase Gasket Exhaust.
11 of 43 people
found this instruction helpful.
-
Alberto from PALMETTO BAY, FL
- Really Easy
- 30 - 60 mins
-
Socket set
Remove the spark suppresser, 4 face screws, 2 bottom screws and the two screws the hold the gasket. I also had to back out the top screw of the cover it blocked and prevented the removal of the gasket.
Was this helpful?
Thank you for voting!