13207 Dynabrade Sander Polisher - Parts

This is an authentic component which is sourced directly from the original equipment manufacturer for use with Dynabrade equipment. This part is made of layered fabric and laminate and is used to spin the rotor. This part is designed to slowly wear down over time, to avoid damage to the cylinder. It is advisable to replace all the rotors ...Read moreat the same time for even wear. Keep in mind these high-quality blades are sold in a pack of four. Please make sure to check the owners manual and the appropriate diagrams of your model for the correct location and application of these parts.

This authentic manufacturer-sourced component is specially designed for use with Dynabrade power tools. It is an identical replacement for a missing or a faulty hardware that was installed on a new unit. Please make sure to check the owners manual and the appropriate diagrams of your model for the exact location and application of this pa...Read morert. Keep in mind this high-quality speed regulator assembly is made of durable material and is sold individually.

This is a manufacturer sourced replacement seal. It is specially produced for use with Dynabrade sanders. This is one of the seals for the tip valve/inlet bushing. Over time seals tend to shrink and crack allowing for air leaks. At that time it should be replaced to maintain top performance. It is made out of rubber material and it is sol...Read mored individually. Replacing this item you would need a wrench to replace this item.

This an authentic Dynabrade replacement part used in buffers and sanders. The spring is used to absorb shock from the valve when tool is in use. It goes between the air control ring and the tip valve. A wrench may be needed to properly install this part. This item is available as an individual replacement part.

This is a genuine OEM part. The Dynabrade tip valve is manufactured for use with orbital sanders, finishers and grinders. This metal and plastic valve often sits in the air inlet bushing, and is supported by a spring. The valve is sold individually, please see specific manual for additional repair information. A pair of pliers, wrench and a screwdriver may be necessary for installation.

It is a genuine OEM part that is designed for Dynabrade grinders and sanders. The valve stem is an important component that connects to the speed regulator assembly. It provides an identical replacement for a damaged or a missing part that was installed on a new unit. Check the owner's manual and the diagrams for your model to ensure the ...Read moreproper repair procedure. Keep in mind this high-quality valve stem is made of durable metal and is sold as an individual item. A screwdriver, a wrench set, and pliers might be needed to replace this part.

It is a genuine item that is supplied by the original equipment manufacturer for Dynabrade tools. This special item is utilized to provide a tight seal between connected components. Unfortunately, over time the material will wear out and it may begin to crack eventually requiring a replacement. Keep in mind this high-quality part is made ...Read moreof durable material and is sold as an individual item. Refer to the appropriate diagrams for your model to ensure the correct repair procedure.

It is a genuine replacement part that is supplied by the original manufacturer for use with Dynabrade grinders. The lever provides a user with a comfortable grip to control the tool's throttle. It is an identical replacement for a damaged or a missing part that is installed on a new tool. To ensure the proper repair procedure, check the d...Read moreiagrams for your specific model. A screwdriver will be needed to take apart the housing when replacing this safety throttle lever.