My Orders
12F802-1969-B1 Briggs and Stratton Engine - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Mower was submerged in Hurricane Matthew
25 of 51 people
found this instruction helpful.
Total disassemble, clean out water and any rust. hone cylinder, wire brush where needed,reassemble with new rings,gaskets and seals and lucas oil product. Started on second pull. Mowed lawn. If you have never done this sort of work before, probably should not attempt.
Other Parts Used:
Was this helpful?
Thank you for voting!
Smelled Gas Leaks
8 of 11 people
found this instruction helpful.
Inspected/removed fuel lines and found signs of leak. Removed and inspected carburetor and found that seals and gaskets were toast. Replaced said seals with ones from the kit that fit and replaced fuel lines.
Would be nice to have a fuel line kit with the big fuel line (tank to carb) and the little one (carb to engine) together ... Read more with all the necessary clamps.
Would be nice to have a fuel line kit with the big fuel line (tank to carb) and the little one (carb to engine) together ... Read more with all the necessary clamps.
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
Mower body was die cast and in good condition. Engine was burning oil.
5 of 8 people
found this instruction helpful.
Removed engine, no specialty tools required. Honed the cylinder, and lapped the valves. Tip on compressing valve spring for reassembly; compress springs with you finger and tie them with 2 zip ties, cut the zip ties after installing the keepers. Repainted the mower deck and engine. It runs and looks like new. My Toro is a 1999 model .
Other Parts Used:
Was this helpful?
Thank you for voting!