All Installation Instructions for Troy-Bilt Lawn Mower 12A-562Q711

Cable was frozen and bail was broken

5 of 6 people found this instruction helpful.

Charles from MIDVALE, OH
Very Easy
Less than 15 mins

I removed the bail and removed cable from motor! Then it was ready for new parts installation!
I attached the cable to the motor and I put the right side of bail in its hole and I then installed cable into the bail and then installed the left side of bail into its hole!! Once that was completed I used two zip ties to cinch down cab ... Read more

Read less

Other Parts Used:

Lawn Mower Blade Control Cable

Lawn Mower Control Handle

Was this helpful?

Not the exact fit

3 of 5 people found this instruction helpful.

Jay from GERRY, NY
A Bit Difficult
30 - 60 mins

I had to drill and tap the ends of the axle and put a 1/4” bolt in to fasten the wheels. The hubs were not the same. They fastened differently.

Was this helpful?

Front drive wheels were wore out

2 of 5 people found this instruction helpful.

Ronald from WAYNE, MI
Very Easy
Less than 15 mins
Socket set

Unbolted old wheels and bolted new wheels to my lawn mower

Was this helpful?

The treads on the front drive wheels were worn down to the point that they provided little traction.

3 of 10 people found this instruction helpful.

MICHAEL from Kennewick, WA
Really Easy
Less than 15 mins
Socket set

Removed a single nut on each end of the drive shaft with the appropriate socket. Wheels then slipped off. Cleaned/polished the shaft with fine sandpaper, lubed with silicone spray, slid on the wheels and reinstalled the nuts with the same socket. Wheels were an exact fit and OEM quality. Done in 15 minutes start to finish.

Was this helpful?

12A-562Q711 (2009) Troy-Bilt Lawn Mower - Instructions