12302 (1988) Kenmore Range - Parts

This is a surface burner knob. This knob is a little under 2 inches in diameter. It is a black part with gray numbering indicating the temperature level of the surface burner: low, medium, high, off, and lite. This knob is made entirely of plastic. Its function is to allow the user to control the heat coming from the surface burner on the...Read more range. This model will only accept a D-shaped shaft. To make this repair, grab the knob with a tight grip and pull it straight off the shaft. When you receive your new part, you can snap it back into place.

The function of the grease filter is to trap grease into the filter from the exhaust air. The grease filter is intended to be used with certain downdraft cooktops and ranges. This grease filter is roughly fourteen inches long and almost twelve inches wide, and chrome in color. Removing your old grease filter and replacing it with a new on...Read moree is an easy job, users say it took them less than fifteen minutes to install. We recommend that when removing your current grease filter, you use work gloves to protect your hands and clean the entire area thoroughly before installing the new filter.

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.

This screw is sold individually.

This down-draft fan switch kit comes with the switch itself and two metallic push nuts. At 125 volts,this switch will allow for 6 amps, and at 250 volts, this switch will allow for 250 volts. This switch runs at 1/4 horsepower.

This wall vent cap kit comes with a spring loaded damper and instructions. It is designed for a 6" diameter outside vent.

This wall vent cap kit comes with a spring loaded damper. This part can be painted.

This jar is a little over five inches long. It is made of glass and is used for collecting the grease drippings of gas ranges.

This spark igniter electrode has a 35" wire lead.

This spark ignition valve switch is an inch and a half long. It is a white switch with a black cam. Sold individually.

This motor isolator is less than an inch long.