12104 Jenn-Air Cooktop - Parts

The function of the grease filter is to trap grease into the filter from the exhaust air. The grease filter is intended to be used with certain downdraft cooktops and ranges. This grease filter is roughly fourteen inches long and almost twelve inches wide, and chrome in color. Removing your old grease filter and replacing it with a new on...Read moree is an easy job, users say it took them less than fifteen minutes to install. We recommend that when removing your current grease filter, you use work gloves to protect your hands and clean the entire area thoroughly before installing the new filter.

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.

This screw is sold individually.

The hinges control the rate that the oven door opens and closes, and allows the door to stay open at an angle. This hinge can be used on either the left or right hand side of your oven, and is approximately 20 1/2 inches long. If your oven door will not open or close easily, you may need to replace this part. It may be a good idea to repl...Read moreace both hinges at the same time. If a spring has become loose on one hinge, the other hinge is likely to have the same issue. The repair is simple and only requires a Phillips screwdriver and a small bent nail. For a full step-by-step guide, check out the video below.

This pan sits under the burner to catch anything that may spill over to make cleaning up easy. Also known as Aeration Pan. Sold individually.

This burner grate kit contains two burner grates. Each grate in this kit is black and ten inches long.

This jar is a little over five inches long. It is made of glass and is used for collecting the grease drippings of gas ranges.

This spark igniter electrode has a 35" wire lead.

This spark ignition valve switch is an inch and a half long. It is a white switch with a black cam. Sold individually.

This motor isolator is less than an inch long.

This bracket supports the front and rear burner assembly.