114708 Briggs and Stratton Engine - Parts

This item has been sourced from the original manufacturer to ensure quality. The breather assembly is intended to be used with lawnmower engines from Briggs & Stratton and Toro. The breather assembly attaches to the crankcase. This item is used to allow gasses to escape the crankcase while retaining oil. This assembly includes the breather and the gasket.

This is an authentic OEM part from Briggs and Stratton and Toro for use with garden equipment engines. The stop wire connects the ignition coil to the stop switch to ground the spark voltage to the engine block when you release the bail control bar. This part is sold individually. The tool that you will need to replace the stop wire is pliers.

This is an authentic replacement part that has been sourced from the original manufacturer to be used with small engines from Briggs & Stratton and Toro. The metal screw is used to secure the muffler deflector or to secure the starter clutch to the flywheel. This item is available as an individual replacement part.

This is an authentic manufacturer-sourced replacement gasket which is specially designed for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. It is generally utilized to provide an air-tight seal for the breather, please make sure to check the appropriate diagrams of your model for the correct applicat...Read moreion of this hardware. Over time it may wear out and begin to fail eventually requiring a replacement.

This is genuine OEM sourced part and is specially designed for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. It is an identical replacement for a missing or damaged spring that was originally installed on a new unit. The purpose of this hardware is to apply tension on the exhaust and intake valves. ...Read moreMake sure to refer to the owners manual and the appropriate diagrams of your model for the correct installation of this component. This high-quality spring is made of durable metal and is sold individually. To replace it, you will need to unscrew and remove the cylinder head. This will allow you to take out the valve and replace the spring.

This is an authentic Briggs & Stratton replacement part. The screw is designed by the manufacturer for use in engines such as those found in tillers, blower-vacuums, and lawn tractors. This part is made of metal, and is generally used in securing the bell crank. Please be aware that there are different screws used in the machine. Refe...Read morer to the parts diagram to be sure of ordering the correct part. You will require a wrench when replacing this part. This item is sold individually.

Kit-Carb Overhaul

This is a genuine replacement part sourced from the original manufacturer for use with small engines. The special starter rope is used to engage the starter pulley when starting the engine. This starter rope is available as an individual replacement part, please see model diagram for associative parts.