11081664310 Kenmore Washer - Parts

This part is the replacement water inlet hose for your washer. It is black in color, made of plastic, and is approximately 19 inches long. The water inlet hose connects the water inlet valve to the water fill nozzle. Over time the hose can become cracked and damaged, and this can cause it to leak. A damaged hose will need to be replaced. ...Read moreBe sure to disconnect the water supply to the washer before you begin this repair. You should also determine if any of the other parts that transport water into the washer are leaking, and if they need to be repaired as well. This part is sold individually and is a genuine OEM part.

This gray and white washer lid bumper contains a rubber bottom and is sold individually.

This clutch band and lining kit helps control the washer's spin cycle by regulating the transfer of power between the drive system and the wash basket. It allows the basket to gradually reach full spin speed, helping remove excess water from clothing at the end of the cycle. If the washer is spinning slowly, leaving clothes wet, making un...Read moreusual noises, vibrating excessively, or not spinning at all, a worn clutch may be the cause. Replacing the clutch components with this kit can help restore proper spin performance, improve water extraction, and keep the washer operating efficiently. The kit includes the key parts needed to repair the clutch assembly and restore reliable operation.

Sold individually.

Found on the water inlet valve.

This seal is for the top of basket drive tube shaft.

Used to put a space between the cabinet and the top of the washer.

This hose can handle hot or cold water and is five feet long.

This is a 2-speed drive motor for your washing machine. The motor rotates the spin basket when the washing machine is in spin or tumbling mode. You will likely need to replace the motor if you are experiencing burning smells or your washer will not start. The tools you will need to make this repair include a number two Phillips screwdriver, a flat-blade screwdriver, and a 5/16 nut driver.

Appliance spray paint is a great way to cover up any chips and scratches that have appeared on your appliances. Instead of replacing the part entirely, this is an easy fix. This is also a great way to give a fresh new look to any handles or areas that have discoloring due to wear. Make sure to clean the area before you begin and wear a pr...Read moreotective mask for safety. Give the can a good shake and spray a few inches away from the surface. Apply the paint until the area is fully covered as desired. Wait until the paint has dried before using the appliance.

This screw is sold individually.