- Home
- 1106004802
- Instructions
1106004802 Kenmore Washer - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
door would not activate dryer......lever broke!
-
nancy from troy, MT
- Really Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers
I am one Happy Gal.....Looked to fix,thought about just buying a new dryer..In the end talked to the local repair guy...said I could do it myself. (why pay him)..I live in small town.Ordered your part,watched the video and did it...Saved myself over $500, plus the $125 for delivery.for that new dryer..(Small town in the forest!)Very easy
... Read more
to install....Hope to use this dryer for many months perhaps years..It is 30 years old! Works like a champ! Thank You!
Read less
Was this helpful?
Thank you for voting!
Dryer won't start
-
Michael from Cincinnati, OH
- Easy
- 15 - 30 mins
-
Screw drivers
Located broken front door safety switch actuator. Ordered new part shown on the diagram. Removed broken part, installed new part, start dryer,runs fine.
Was this helpful?
Thank you for voting!
My dryer would not work when I closed the door.
-
Michael from Hudson, NH
- Easy
- 15 - 30 mins
-
Nutdriver, Pliers, Screw drivers
I thought it might be a damaged switch but when I removed it I noticed a metal clip that was attached to it was broken. The pin on the door pushes against this clip when the door is closed which in turn opens the circuit on the switch. I looked up the model on this website and viewed the parts diagram. There I saw the part I needed and it
... Read more
was listed below along with the cost. Couldn't of been easier. Thanks!
Read less
Was this helpful?
Thank you for voting!
dryer would not run
-
Jeffery from Cordova, AL
- Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers
removed 4 screws. 2 in the back and 2 at the lint screen door. Remove top lid of dryer and looked down and there was the door switch with the broken actuator spring. A diagram of the dryer with part locations is very helpful. I checked the switch with volt meter to make sure it was ok. It was ok! Replace the actuator and put every thing b
... Read more
ack together and dryer works just fine. Thanks to PartSelect I was able to buy the actuator spring buy itself and not have to buy the switch also.
Read less
Was this helpful?
Thank you for voting!
actuator spring lever broke
-
george from port angeles, WA
- Easy
- 15 - 30 mins
-
Screw drivers
two screws on filter housing and then lift dryer to up like the hood of a car the two screws on actuator, be careful not to drop actuator, if you do use a magnet to retrieve, two screws back in then wire clip top of dryer down and two screws back into filter housing and your ready to dry clothes, not recommended but if you have to dry clo
... Read more
thes while waiting for part a clamp on the switch will allow you to use dryer, but be extremely careful because dryer will not turn off when door is opened
Read less
Was this helpful?
Thank you for voting!