1105804700 Kenmore Washer - Parts

This part may also be referred to as a main outer tub seal. This part prevents leaking from the bottom of the tub. The gasket is approximately 2 inches in diameter to the outer edge, black in color, and made of plastic material. To perform this repair, you will need to disconnect the power, drain hose, and the inlet hose. You will need to...Read more remove the entire outside cabinet to have access to the tub assembly. The tub will need to be removed entirely. This is a genuine part that is sourced directly from the manufacturer.

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be care...Read moreful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

This is the bearing for the lid hinge. Sold individually.

This spanner nut, also referred to as a lock nut, is a critical component that secures the inner tub to the drive block in large-capacity washers. Featuring a right-hand thread, it ensures the tub remains firmly in place during wash and spin cycles, preventing excessive noise, shaking, or vibration. A worn or damaged nut can lead to poor ...Read moreperformance and operational issues. Installation requires basic tools and disassembly; always disconnect power and water supply before beginning the repair.

Sold individually.

This clamp helps to prevent leaking by holding the end of water hose in place.

Sold individually.

This is the hose that tells your appliance if your tub is at the desired water level.

Right Side - This lid hinge is for washers. Lid hinge connects the lid to the top panel and allows the lid to pivot open and closed. Wear work gloves to protect your hands when installing this part.