11051 - Parts

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

This is a lid strike for various models of top-load washing machines. Lid strikes are designed to engage with the lid switch and communicate to the control board that the washer can start. If your washing machine is having issues starting, or if the lid strike for your washer is visibly damaged it will need to be replaced. Replacing this ...Read morewashing machine lid strike is simple and only requires a screwdriver. This lid strike is made almost entirely of durable white plastic and features two holes on either side for securing with screws. This lid strike is an OEM part and is not sold with any other parts or accessories, such as the necessary screws.

This is a shift actuator, and is designed for use in washing machines. This shift actuator is made to change the mode of the motor between spin and agitate, as well as communicate with the control board how fast the washer is spinning. If the shift actuator in your washer is broken or bad, it can lead to the washer not spinning or agitati...Read moreng correctly and may even show an error code related to that. This shift actuator is made mostly of plastic but does feature a 120V/60HZ/2.8W motor. This actuator is an OEM part and is sold individually.

This washer drive block is an essential component that connects the inner spin basket to the drive shaft, enabling proper spinning during wash and spin cycles. Measuring approximately 2-5/16 inches high, it is designed for large-capacity washers with belt or direct drive systems. A worn drive block can cause loud noises, shaking, poor spi...Read morenning, or leave clothes excessively wet. Installation requires basic tools and disassembly; always unplug the appliance and shut off water supply before starting the repair. Regular inspection and timely replacement help maintain optimal washer performance.

This gray and white washer lid bumper contains a rubber bottom and is sold individually.

The drain hose carries used water from the washer to your house drain.

Appliance spray paint is a great way to cover up any chips and scratches that have appeared on your appliances. Instead of replacing the part entirely, this is an easy fix. This is also a great way to give a fresh new look to any handles or areas that have discoloring due to wear. Make sure to clean the area before you begin and wear a pr...Read moreotective mask for safety. Give the can a good shake and spray a few inches away from the surface. Apply the paint until the area is fully covered as desired. Wait until the paint has dried before using the appliance.

This genuine OEM drain pump is designed for washing machines. It is responsible for removing the wastewater from the machine during the drain cycle. The drain pump works by creating suction to draw water out of the tub and push it out through the drain hose. Signs of a faulty drain pump include the washer failing to drain water properly, ...Read moreleaving clothes wet at the end of the cycle, or loud, unusual noises during the drain cycle, such as grinding or humming sounds. Additionally, if the drain pump is visibly damaged, or leaking, then it likely needs to be replaced. You can find the drain pump located at the bottom of the washing machine.

This control knob is for dryers. Control knob lets you control cycle settings. Remove the knob by pulling it straight off its post.

Sold individually.

This is the bearing for the lid hinge. Sold individually.