My Orders
- Home
- 11029133410
- Instructions
11029133410 Kenmore Washer - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
replaced drain hose that was missing
12 of 20 people
found this instruction helpful.
-
Delmar from EAST TROY, WI
- Really Easy
- 30 - 60 mins
-
Pliers
slipped the new drain hose on and with locking plyers slipped the wire clap in place after three trys
Was this helpful?
Thank you for voting!
Lid would not lock, therefore, washer would not start.
6 of 8 people
found this instruction helpful.
-
Patricia R from BROOKHAVEN, MS
- Really Easy
- 15 - 30 mins
-
Pliers, Screw drivers, Wrench (Adjustable)
I watched a YouTube video first. Followed instructions exactly and had washer going in 30 minutes!!!! Part that I ordered was an exact fit! Thanks to partselect.com!
Was this helpful?
Thank you for voting!
washer would start then stop with everything flashing
5 of 7 people
found this instruction helpful.
-
Lee from MURPHY, NC
- Easy
- 15 - 30 mins
-
Pliers, Screw drivers
UNPLUG WASHER FROM WALL PLUG
Watch u tube on how to remove top and also cover on top circuit compartment
First find the service book taped inside front. PLUGand read to read codes
call up the error codes flashing
the code indicated a defective lid latch.UNPUG WASHER
went through testing the switch one of the cont ... Read more acts was defective and intermittent.
UNPUG WASHER unpug J connect from circuit board remove wiring and connect from lid
new wiring harness goes back same as old one and mount new lid switch. done
Watch u tube on how to remove top and also cover on top circuit compartment
First find the service book taped inside front. PLUGand read to read codes
call up the error codes flashing
the code indicated a defective lid latch.UNPUG WASHER
went through testing the switch one of the cont ... Read more acts was defective and intermittent.
UNPUG WASHER unpug J connect from circuit board remove wiring and connect from lid
new wiring harness goes back same as old one and mount new lid switch. done
Read less
Was this helpful?
Thank you for voting!
Top panel was rusted above soap drawer
3 of 3 people
found this instruction helpful.
-
Cheryl from ELMIRA, NY
- A Bit Difficult
- More than 2 hours
-
Pliers, Screw drivers, Socket set, Wrench (Adjustable)
My husband watched numerous YouTube videos before tackling it.
Was this helpful?
Thank you for voting!
broken lid latch
2 of 2 people
found this instruction helpful.
-
James from CLINTON TWP, MI
- Really Easy
- 30 - 60 mins
-
Nutdriver, Pliers, Screw drivers
move washer to get to backside, remove necessary screws and hoses, slid washer top over, replaced lid mechanism.
Was this helpful?
Thank you for voting!
Replace drain hose
3 of 11 people
found this instruction helpful.
-
Brian from DREXEL HILL, PA
- Easy
- 30 - 60 mins
-
Pliers
At first I had to position the washer so I could get access.. after having it positioned, I figured it out. Getting the clamp fastened, I was done.
Was this helpful?
Thank you for voting!