10T7 Briggs and Stratton Engine - Parts

This is an authentic exhaust muffler specially designed for Briggs and Stratton engines commonly used on Toro lawn and garden equipment. It is supplied directly from original equipment manufacturer and it is sold individually. Muffler softens the noise coming from the engine and provides an additional layer of filtration of exhaust. This metal muffler is manufactured to meet EPA exhaust regulations.

The stop switch is made of plastic and metal and helps to turn off the device. This is an authentic replacement part that is sourced from the original manufacturer for use with engines, generators, snowthrowers, and blower-vacuums made by Toro, Murray, and Briggs & Stratton. This part is available individually. During the installation pro...Read morecess, a wrench set and wire stripping pliers might be needed to replace this part. It may become bent or broken and will need to be replaced.

This is an authentic OEM component from Briggs & Stratton. The magneto armature screw is compatible with many lawn and garden engines. The hardened metal screw helps to mount the magneto armature. A wrench is required for the removal and installation. The magneto armature screw is sold individually. It is recommended to refer to engine manual and diagrams for further instruction.

This is a genuine Briggs and Stratton part for use with Lawn and Garden Equipment Engines. The carburetor needle valve seat gasket makes a seal between the needle valve and the base of the carburetor. This part is sold individually. The most common reason for replacing a gasket is if the carburetor is leaking fuel. The tool that you will need to replace the seal gasket is a 10mm socket.

This is a genuine OEM sourced replacement part used on Briggs and Stratton engines. The purpose of this part is to mix air and gas before the fuel mix goes to the engine. If the engine won't start and the tank is full of fresh fuel, test the carburetor by removing the air filter and pouring about a teaspoon of fuel into the carburetor. P...Read moreull the starter rope. If the engine starts and then quickly dies, the carburetor is likely the problem. This is a plastic body carburetor, it is sold individually. This assembly includes gaskets, diaphragm, governor spring. You will need a screwdriver to perform this repair.

This is a genuine manufacturer-sourced component which is specially produced for Briggs and Stratton engines commonly installed on lawn and garden equipment. It is a standard hardware that is generally utilized to secure the debris screen guard, please make sure to refer to the appropriate diagrams of your model for the correct location a...Read morend use of this screw. Keep in mind it is a high-quality component which is made of durable metal and is sold individually.

It is an authentic manufacturer-sourced part which is made for use with Briggs and Stratton engines that are commonly installed on a variety of lawn and garden equipment. This is the special screw which helps to secure the air cleaner. This will provide an identical replacement for the original part that was installed on a new unit. This ...Read morehigh-quality screw is made of durable metal and is sold as an individual item. Make sure to refer to the appropriate diagrams for your model to ensure the proper replacement procedure. A screwdriver will be needed to perform this repair.

This item has been sourced from the original manufacturer to be used with small engines from Briggs & Stratton. The metal spring is used to actuate the governor control assembly. This spring is sold as an individual replacement part.

This is an authentic replacement part manufactured for use with small engines. This oil seal keeps oil inside the crankcase, and seals the shaft. It is recommended to replace the crankcase gasket when servicing the case, the gasket is available separately. The oil seal is sold individually.