My Orders
1088B06 Roper Range - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Bulb worked for a couple days and has now burned out, filaments dangling
3 of 4 people
found this instruction helpful.
-
Amy from JUNCTION, TX
- Easy
- Less than 15 mins
-
Screw drivers
To replace the light bulb, I removed the screw and the cover, unscrewed the old bulb, replaced with the new bulb and replaced the cover, securing it with the small screw. It worked appropriately with normal use for a few days and then I noticed the light was not coming on when I opened the door.
I removed the cover and pulled ... Read more out the bulb to find that the filaments inside are dangling and burned through. I need them replaced, please.
I removed the cover and pulled ... Read more out the bulb to find that the filaments inside are dangling and burned through. I need them replaced, please.
Read less
Was this helpful?
Thank you for voting!
light wont come on
4 of 9 people
found this instruction helpful.
-
James from Fort Collins, CO
- A Bit Difficult
- 1- 2 hours
-
Pliers, Screw drivers, Wrench set
Well, when you put the back cover on and screw it down make sure you have nothing touching the white wire leading to the oven light. I did and it blew the push switch when I threw the 220 breaker. Actually, the light was on when I came in the room, but when I pushed the switch on the front panel it sparked in the rear and popped the break
... Read more
er. Then I saw the short and when I tested the switch it would not click. The install was fine.
Read less
Was this helpful?
Thank you for voting!