1069450211 Kenmore Refrigerator - Parts

This screw is sold individually.

The speed nut (also referred to as a condenser motor fan nut), fits onto the condenser fan motor. The motor for this fan turns on simultaneously with the evaporator and the compressor motors, so a malfunction in the condenser fan motor could cause your fridge to cycle on and off more frequently or run too warm, or too noisily. Make sure t...Read morehat the speed nut is properly attached and tight. Check the nut for any signs of wear or damage. If the nut is damaged and refuses to tighten, you should replace the part immediately. Remember to unplug your refrigerator before starting this repair.

Sold individually.

This is an ejector arm, and it is used in conjunction with your refrigerator. The function of this part is to act as a cube ejector inside your ice maker. The arm will rotate inside the ice maker to allow the ice cubes to fall out of the marker and into the ice bucket. This part is made entirely of plastic, is white in color, and has eigh...Read moret teeth. It measures just over 9 inches long, and one and a half inches wide. To make this installation the tools you will need include a quarter-inch nut driver, a flat-head screwdriver, and a Phillips screwdriver.

Sold individually.

This bracket is used in conjunction with the ice maker.

The defrost heater keeps the cooling coils from frosting over.

This is a 12oz (about 355 ml) can of black spray paint that is compatible with a variety of different home appliances and is used to cover and conceal any visible scuffs, scratches or chips. This can is sold individually, so consider how much paint you need for your appliances prior to placing an order. To use this spray paint, make sure ...Read moreto have the proper personal protective equipment, such as protective glasses or gloves, as well as a respirator. Clean the surface of whatever you are spraying before you begin and shake the can for 1 minute after hearing the internal mixing balls rattle. Do not spray during high heat or humidity, spray at room temperature and in several thin coats to ensure the best adherence.