1069412382 Kenmore Refrigerator - Parts

The compressor relay and overload kit is an assembly for your refrigerator. The function of the overload is to protect the compressor from overheating by being mounted to the side of the compressor. The purpose of the relay is to boost the compressor. This assembly comes with two smaller plastic pieces that are less than two inches by one...Read more inch. One is black and the other is white. The kit also comes with a red wire tubing. The most common reason for needing to replace the overload and relay is if your fridge is too warm or will not start.

This air diffuser controls the amount of cold air distributed through the refrigerator.

Start relay and overload for production compressor only. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed. The overlay provides added protection against excessive current and against excessive temperature use.

This white door gasket is used to seal the freezer door when closed.

Sold individually.

This screw is sold individually.

The speed nut (also referred to as a condenser motor fan nut), fits onto the condenser fan motor. The motor for this fan turns on simultaneously with the evaporator and the compressor motors, so a malfunction in the condenser fan motor could cause your fridge to cycle on and off more frequently or run too warm, or too noisily. Make sure t...Read morehat the speed nut is properly attached and tight. Check the nut for any signs of wear or damage. If the nut is damaged and refuses to tighten, you should replace the part immediately. Remember to unplug your refrigerator before starting this repair.

Sold individually.

Sold individually.

Sold individually.