106940 Kenmore Refrigerator - Instructions

First I had to tilt the refrigerator on wood on the supports under the refrigerator, the wheels were easy to get to then I unscrewed the old ones and replaced them with the new better wheels. The old ones where plastic.

Replaced broken shelf bracket

One of the front studs was broken off. I had to use pliers to pull it out (kind of tight). Then I inserted the back and front holders and layed the shelf back in. Total time...10 min

Just like the video showed me.It still does not work. Have to turn it off and on to make it start up.I also replaced thermostat in freezer. Does not work.

Replaced both since they came as a set. The only way it could have been any easier is if I had the wife do it. She had the remote this time. (•¿•)

Followed the directions. Installation was quick. Took loner to put the covers back on and push the applicance back in position than the repair.

Figured out You have to pop off the cocer than remove the 1/4 hex head screws only not the philips ones

took front knobs off an then cover took side cover off next then disconnected themostat and replaced with new and followed the coil to side to the back of fridge an put back together. Oh by the way I unplugged the fridge first

It was pretty straight forward after all the control panel removed. The plastic tubing was removed from old and installed on new part. Reconnected the connectors and re-route wire to the back vent. After installed covers and control panel, turn on power, it runs.

followed directions given on your video

Part # had been replaced with another timer. Original timer had 2 wires coming out of it. Replacement only had 1 wire. Instructions showed 2 options for where to place the wire. I chose option 2 and I guess I was right. Installation took less than 15 minutes and refridge is back to normal. (Quiet)

it was a simple repair once I located the part I had to replace . I really like your speedy delivery of the part I needed Thank you Pat Crotty

I pried out the broken stud, and tried to put the new one in. There were no instructions, so I put it in, but it was loose and unusable. Also, I ended up with the wrong type of shelf stud - I had a rear one instead of a front one. So, I used gorilla glue and duct-taped the stud in place and let it harden overnight. It doesn't look gre ... Read more at, because it sags a bit, but the glue is holding and the shelf stays up now.

Forty years ago I serviced air conditioners and all kinds of refrigeration. At that time starting relays were electro mechanical, I hadn’t looked under a refrigerator in a lot of years and was surprised to find out that the new relays were solid state. The defective one had a bunch of broken pieces floating around in the case. I jury rigg ... Read more ed a starting cord and confirmed that the compressor would start and looked at running current for thirty or so seconds. I ordered a new relay kit and it worked just right. I’m seventy five years old and it takes me longer to get up off the floor than it took to replace the parts. Your delivery was first rate the parts got here before I finished doing the paint touch-up on the door under the ice maker/water dispenser. Fed ex was easily three to five days faster than the brown truck.

unplugged relay and plugged in