10689582706 Kenmore Ice Maker - Parts

A recirculating pump is used with standalone ice cube makers. It circulates the water over the top of the evaporator plate, which produces a layer of ice that is then broken down into ice cubes. If you notice that your ice maker is no longer producing ice or there is no water flowing over the cooling plate, this could be due to the recirc...Read moreulating pump not working. Be sure to keep the pump clean and free of build-up. This pump is 5.75 inches in length, 4.75 inches in width, 4.25 inches in height and weighs 0.81 lbs. This is a genuine OEM appliance part that comes directly from the manufacturer.

If your freestanding ice maker is not producing ice properly, the ice cutter grid assembly may need replacing. The cutter grid is located within the main unit of the ice maker and contains thin, heated wires that slice the ice into cubes that are then deposited in the ice bin. If the cutter grid is broken, ice can back up within the ice m...Read moreaker. This part is sold as a complete assembly and is used with freestanding ice makers. Be sure to wear work gloves to protect your hands when completing this repair. This is an OEM part that sources directly from the manufacturer.

There is approximately 10' of wire. Note: 2 kits are needed to replace both directions.

This is a temperature sensor. It may also be known as an ice maker sensor and is used in conjunction with your ice machine. This piece is roughly 3.5 inches long, almost 2.5 inches wide, and includes the necessary wiring connector. You will find this part located in the water pump area of the ice cube maker. The function of this part is t...Read moreo determine the water level within the water reservoir. Once the water level reaches a certain point, the sensor will signal the controls to fill the reservoir.

This part is a drain pump for your ice maker. When you flush the reservoir on your ice maker to remove impurities, the drain pump is the part that removes the water from the reservoir. This is an authentic OEM part sourced directly from the manufacturer. Disconnect power to your refrigerator before making this repair.

This is a drain fastener cap and is used in conjunction with your freezer/refrigerator. This model is almost 1.5 inches in diameter, half an inch thick, and is white in color. This piece will fasten to the bottom of the water pan in your ice maker. It keeps the water in the water pan from leaking into your appliance. If your drain cap is ...Read moreloose or broken, the liquid from the water pan will empty and you will have no ice or very thin ice. Make sure when replacing this part to secure the drain cap tightly.

The water distributor tube distributes water from the reservoir to the evaporator plate.

This water bucket provides contained storage for collected water or ice within the appliance. Its durable construction supports regular removal and cleaning. Replacing a cracked or damaged bucket helps prevent leaks and maintain proper operation.

The connection ports on the water inlet valve are John Guess fittings. To remove, it is recommend to push the line in and then hold the ring in. While holding the ring in, pull the line out. To re-install, push the line in until there is resistance. Push until the line "pops" in another 1/4". Pull on the line with out touching the ring to seat seal. This is a genuine OEM part and inclused 5/16" inlet tube.

This part includes the recirculation pump and motor sensor.

Screw size is 8-18 x 5/8". Used with stand-alone ice cube makers.

This screw is sold individually.