1068618421 Kenmore Refrigerator - Parts

For the bottom of refrigerator door handle - for Platinum model only.

This cold control thermostat has a temperature range from 36 degrees Fahrenheit to 17 degrees Fahrenheit and a capillary length of 26 inches.

Sold individually.

This part can be used on either side of the center door hinges for some refrigerators.

This screw is sold individually. It is a genuine OEM replacement part, and it is designed for use with refrigerators. Most often it is used with the ice bucket ice deflector, retainer clip, and front cover. Due to varied uses we recommend referring to model-specific diagrams for exact placement. This screw measures 8-18 by 1/2 inch.

The speed nut (also referred to as a condenser motor fan nut), fits onto the condenser fan motor. The motor for this fan turns on simultaneously with the evaporator and the compressor motors, so a malfunction in the condenser fan motor could cause your fridge to cycle on and off more frequently or run too warm, or too noisily. Make sure t...Read morehat the speed nut is properly attached and tight. Check the nut for any signs of wear or damage. If the nut is damaged and refuses to tighten, you should replace the part immediately. Remember to unplug your refrigerator before starting this repair.

Sold individually.

Sold individually.

This tray is used to collect the access water from the cooling system to prevent water from leaking on to your floor.

Sold individually.