1068469430 Kenmore Refrigerator - Parts

The speed nut (also referred to as a condenser motor fan nut), fits onto the condenser fan motor. The motor for this fan turns on simultaneously with the evaporator and the compressor motors, so a malfunction in the condenser fan motor could cause your fridge to cycle on and off more frequently or run too warm, or too noisily. Make sure t...Read morehat the speed nut is properly attached and tight. Check the nut for any signs of wear or damage. If the nut is damaged and refuses to tighten, you should replace the part immediately. Remember to unplug your refrigerator before starting this repair.

Sold individually.

This tray is used to collect the access water from the cooling system to prevent water from leaking on to your floor.

This is a terminal cover for the compressor in a refrigerator. This covers the relay and overload switch on the compressor. Once you have gained access to the terminal cover, you will see that the cover is held on by a tension or retaining clip. Simply pop the cover off and replace with the new cover. The cover is made of plastic and is b...Read morelack in color. It measure less than 3 inches long and less than 3 inches wide. This is a genuine replacement part from the original manufacturer.

This bottom door hinge kit comes complete with both the left and right hand side.

Sold Individually.

This fan blade circulates air over the condenser. It mounts onto the shaft of the condenser fan motor.

Sold individually.