10657034603 Kenmore Refrigerator - Parts

Helps to maintain the proper temperature in the freezer and fresh food compartments. This part has been updated by the manufacturer and may be difference in appearance.

This is the replacement evaporator drip tray for your refrigerator. It is made of white plastic and is approximately 19 inches by 9 inches. The evaporator drip tray sits below the evaporator to collect dripping water. If the drip tray is damaged, you may notice that your refrigerator is leaking. Because it is made of plastic, the drip tra...Read morey can eventually develop a crack. You will need to pull out the refrigerator from the wall, and take off the bottom panel on the back of your refrigerator in order to access the drip tray for replacement. This is an OEM part sourced directly from the manufacturer.

This washer is sold individually.

Sold Individually - Appliance originally takes 2.

This part is the top hinge for your refrigerator door. It is made of metal and is approximately 5 inches by 3 ¼ inches in size. This hinge is for the right side of the refrigerator door only. The left side hinge is sold separately. The top hinge allows your refrigerator door to open and close properly. If your door is hanging strangely, o...Read morer if the door won’t open or close properly, you may need to replace the top hinge. This part is sold individually and is an authentic OEM part.

This door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Appliance spray paint is a great way to cover up any chips and scratches that have appeared on your appliances. Instead of replacing the part entirely, this is an easy fix. This is also a great way to give a fresh new look to any handles or areas that have discoloring due to wear. Make sure to clean the area before you begin and wear a pr...Read moreotective mask for safety. Give the can a good shake and spray a few inches away from the surface. Apply the paint until the area is fully covered as desired. Wait until the paint has dried before using the appliance.

This dispenser door pin comes with the washer.

This clip is sold individually.

Sold individually.

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

Support wheel assembly with bracket. Kit of 2.