10648 - Parts

This part may come with a plastic or metal auger depending on the factory. It will work with your appliance if found with the model number. (Make sure you install properly at back of ice container, because it must be engaged for the crushed ice feature to work).

This fourteen cube ice cube tray is eleven inches long. It is all white in color and is made entirely of plastic.

This refrigerator door hinge kit is a genuine OEM replacement designed to support the lower hinges of both the freezer and refrigerator doors. Engineered for durability and precision, it ensures smooth door movement, proper alignment, and a secure seal—critical for maintaining temperature stability and energy efficiency. The kit includes ...Read moreboth left and right lower hinges and is compatible with a wide range of models across Whirlpool and affiliated brands. Common symptoms indicating the need for replacement include difficulty opening or closing doors, poor sealing, excessive noise from the hinge area, and misalignment. Installation may require basic tools and should be performed with the appliance powered off.

Appliance spray paint is a great way to cover up any chips and scratches that have appeared on your appliances. Instead of replacing the part entirely, this is an easy fix. This is also a great way to give a fresh new look to any handles or areas that have discoloring due to wear. Make sure to clean the area before you begin and wear a pr...Read moreotective mask for safety. Give the can a good shake and spray a few inches away from the surface. Apply the paint until the area is fully covered as desired. Wait until the paint has dried before using the appliance.

This clip is sold individually.

This kickplate grille is attached to the bottom of the refrigerator.

This kit includes the Relay, Overload and cover. The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed and the Overload provides added protection for the compressor motor because, in addition to protecting against excessive current, it also protects against excessive temperature use.

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

Support wheel assembly with bracket. Kit of 2.

This door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

This kit comes with the compressor relay, overload and cover.

This screw is sold individually.