1060 - Instructions

start with chute auger and punch out roll pins and cotter pin, reassemble linkage with METAL universal gears

First I watched the Parts Select video (Dishwasher Control Panel (Part #00475255 - How to replace) on YouTube just to be sure I could do the replacement. I ordered the part (delivered next day) and replaced the control panel in less than 30 minutes while watching the video. One note, you should be prepared to have a small stool or box t ... Read more o set the electrical components on while swapping the buttons on the control panel. I did not want to leave them hanging by the wires and this is not shown on the video.

Everything went very easy and was done in no time. After I put on new part, mower started right up.

Removed the back - Saw the broken clips on the base of the dryer (the wires to the motor were pulling out because the motor was slipping).

Guessed that the parts were motor clips (no pix in the web site!)

Got the parts in post - they were identical except needed some rubber grips inside to hold tight (Used pieces of ... Read more bike tire inner tube cut to fit for this.) Attached clips. Works fine!!

(Son is an engineer - he found the problem. Husband is a retired doctor - he couldn't!! but together they
supplied the muscle)
Sue (67 years old)

The hub that the mower blade mounts to was brokenPut the new Harbonne played and played securing flange bolted it up

Tip mower onto side, raising side to be repaired. Empty gas tank if possible or use rags to prevent gasoline drips onto clean surfaces.

Remove wheel using a 1/2" socket.
Remove wheel height assembly with 1/2" socket and open end wrench to hold nut below the deck.
Position new spring arm over the slot on wheel height ... Read more assembly plate. Check opposite side to verify correct orientation if needed.
Remove plastic cover from old lever using a small flat blade screwdriver. Slip onto new lever.
Replace wheel height assembly.
Replace wheel.