My Orders
10471 General Electric Range - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Right Oven Door Handle End Cap Broke Off
-
James from Fort Myers, FL
- A Bit Difficult
- 15 - 30 mins
-
Screw drivers, Socket set
Went on line and watched a couple of instr. videos which were very well done and explained just how to replace the end cap. I purchased and relaced both end caps and was able to clean the entire handle before putting it all together. Looks really good now. Thankyou. JJM
Was this helpful?
Thank you for voting!
Trim part on bottom of door was rusty
-
Richard from Euclid, OH
- Easy
- 15 - 30 mins
-
Nutdriver
I ordered the part, It came a few days later,,Within 15-20 minutes, I had it installed..Pretty easy...Thanks
Was this helpful?
Thank you for voting!
The range kept giving an F2 alarm
-
Les from Coal Creek, CO
- Really Easy
- 30 - 60 mins
-
Screw drivers, Socket set
When I got the part I removed the tin cover (two screws)on the back of the range. I removed the sensor by removing the two screws inside the oven and pulled out the sensor. taking the instructions advise, I checked the sensor with my ohm meter and although it read 1.1 ohms as compared with the recommended 1.09 ohms at room temperature in
... Read more
the instructions, went ahead and changed the unit. The connector did not fit my particular model so I spliced the wiring and using the two included wire nuts made the connection. I reinstalled the sensor, reattached the gas line, plugged it in and tried the oven before I put it back in place. The oven works great now and it was super easy.
Read less
Was this helpful?
Thank you for voting!