104-7 Toro - Overview

This Ni Nut-Lock, or Nylock Nut, is a Silver 1/4 x 20 metal nut. Sold individually, it can be adjusted using a wrench or socket and torque wrench to the manufacturer specfications, and is used to secure the sheer pin in place, on the impeller assembly. These nuts are a one-time use part due to their locking mechanism. You'll know the nut...Read more has broken when it appears to have damaged threads or rounded off edges. Customers found this to be an easy repair.

The Fuel Line Clamp is a metal, individually sold part which clamps onto the fuel line, securing it to a port and preventing leaks. Installation is rated as "Easy" by customers and will require pliers and a screwdriver. If broken due to wear/fatigue/damage, there may be a fuel leak and the part should be replaced. Refer to your make, model and diagrams to ensure this is the correct part.

This item is available as an individual replacement part. The gasket attaches to the intake pipe and is made out of a thin material. During replacement, it may require a screwdriver to help install this part correctly. It will require replacing if it breaks. This genuine item is supplied by the original equipment manufacturer for use with...Read more lawn mowers, lawn tractors, and snowblowers made by Tecumseh, Toro, and Lawn Boy.

Start a compatible lawn and garden engine by hand with this recoil starter assembly. Pulling the rope turns the crankshaft so the engine can start. Replace the assembly if the rope is broken, the spring no longer rewinds, or the starter does not engage. Let the engine cool and disconnect the spark plug wire before repair. Check the exact engine model before ordering.

This black OEM fuel cap (1-1/2 ID) is a black plastic cap which attaches to the fuel tank to keep fuel in and keep debris out. If the cap becomes broken due to wear/damage/fatigue there may be a fuel leak, and the part should be replaced. Refer to your make, model and diagrams to ensure this cap is right for you.

This is a genuine OEM sourced hardware that is specifically made for use with Toro lawn and garden equipment. It is a standard hardware which may have multiple applications depending on the model of your unit. Please make sure to refer to the appropriate diagrams for the correct location and application of this part. Keep in mind this hig...Read moreh-quality flange nut is made of durable metal and is sold individually. Note, you will need a wrench to secure or remove it.

This is an authentic replacement part manufactured for use with snowthrowers and lawnmowers. The extension spring is commonly used to link the governor control arm to the control cable. This extension spring is sold individually, please see model diagram for associative parts.

This authentic part is supplied by the original equipment manufacturer for Tecumseh engines commonly installed on Toro lawn and garden equipment. The float is used to allow fuel into the float chamber when the chamber has been drained and to stop fuel from entering the chamber when it is full. It provides an identical replacement for a mi...Read moressing or a faulty component that was installed on a new unit. Refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality float is made of durable plastic and is sold individually.

This O-ring is designed for use with small engine carburetors and is made of rubber, meaning over time and further exposure to fuel, it will become brittle and crack. This O-ring is installed within the carburetor and is located between securing screws near the base. If disassembling your equipment to replace this O-ring, it is recommende...Read mored you inspect the other parts to ensure optimal performance and to prevent any leaks. Featuring an inner-diameter of approximately 0.25-inches, the replacement process for this O-ring in your engine will vary, so check the user manual for exact location of this part.