10321 - Parts

It is made of metal and is sold individually. The tap screw attaches to the panel. When replacing this part a phillips screwdriver may be needed. It will require replacing if it breaks or strips. This is a Toro and Lawn Boy replacement part directly sourced from the manufacturer for use in lawn mowers.

This is a manufacturer sourced replacement seal. It is specially produced for use with Dynabrade sanders. This is one of the seals for the tip valve/inlet bushing. Over time seals tend to shrink and crack allowing for air leaks. At that time it should be replaced to maintain top performance. It is made out of rubber material and it is sol...Read mored individually. Replacing this item you would need a wrench to replace this item.

This an authentic Dynabrade replacement part used in buffers and sanders. The spring is used to absorb shock from the valve when tool is in use. It goes between the air control ring and the tip valve. A wrench may be needed to properly install this part. This item is available as an individual replacement part.

This is a genuine OEM part. The Dynabrade tip valve is manufactured for use with orbital sanders, finishers and grinders. This metal and plastic valve often sits in the air inlet bushing, and is supported by a spring. The valve is sold individually, please see specific manual for additional repair information. A pair of pliers, wrench and a screwdriver may be necessary for installation.

It is a genuine OEM part that is designed for Dynabrade grinders and sanders. The valve stem is an important component that connects to the speed regulator assembly. It provides an identical replacement for a damaged or a missing part that was installed on a new unit. Check the owner's manual and the diagrams for your model to ensure the ...Read moreproper repair procedure. Keep in mind this high-quality valve stem is made of durable metal and is sold as an individual item. A screwdriver, a wrench set, and pliers might be needed to replace this part.

This is a genuine item that is supplied directly from the original equipment manufacturer for use with Dynabrade sanders. It is an identical replacement for a missing or faulty inlet bushing that the compressor hose would connect to, please make sure to refer to the appropriate diagrams of your model for the correct location and applicati...Read moreon of this hardware. Keep in mind this high-quality item is made of durable metal and is sold individually.