10288 Dynabrade Sander Polisher - Parts

It is a genuine replacement o-ring which is supplied by the original equipment manufacturer for use with Dynabrade power tools. This item is utilized to provide an air-tight seal between connected parts, please make sure to check appropriate diagram of your model for the correct use and location of this component. Over time o-rings tend t...Read moreo deteriorate and crack eventually requiring replacement to maintain peak performance. It is a high-quality part that is made of durable rubber material and it is sold individually.

Genuine Dynabrade replacement part, this item is sold individually. The purpose of the 56027 Muffler is to lessen the noise of the air coming from the exhaust of the tools listed below. It will also filter out the excess oil that is in the tool. Once these Inserts get dirty and clogged they should be replaced.

This is a manufacturer sourced replacement seal. It is specially produced for use with Dynabrade sanders. This is one of the seals for the tip valve/inlet bushing. Over time seals tend to shrink and crack allowing for air leaks. At that time it should be replaced to maintain top performance. It is made out of rubber material and it is sol...Read mored individually. Replacing this item you would need a wrench to replace this item.

This an authentic Dynabrade replacement part used in buffers and sanders. The spring is used to absorb shock from the valve when tool is in use. It goes between the air control ring and the tip valve. A wrench may be needed to properly install this part. This item is available as an individual replacement part.

This is a genuine OEM part. The Dynabrade tip valve is manufactured for use with orbital sanders, finishers and grinders. This metal and plastic valve often sits in the air inlet bushing, and is supported by a spring. The valve is sold individually, please see specific manual for additional repair information. A pair of pliers, wrench and a screwdriver may be necessary for installation.

This is a genuine item that is supplied directly from the original equipment manufacturer for use with Dynabrade sanders. It is an identical replacement for a missing or faulty inlet bushing that the compressor hose would connect to, please make sure to refer to the appropriate diagrams of your model for the correct location and applicati...Read moreon of this hardware. Keep in mind this high-quality item is made of durable metal and is sold individually.