0921 Briggs and Stratton Generator - Parts

This is an OEM part sourced directly from the manufacturer. The brush is designed for use in generators from Briggs & Stratton. This part is a complete carbon brush assembly, which is used to supply power to the rotor. You may require a screwdriver or Allen wrench when replacing this part. This item is sold individually.

This connector is sourced from the original manufacturer as a replacement part for use in generators. The connector has 6 pins/terminals which allow the joining of various electrical cables and components in the generator. Over time the connector can break or wear down, rendering it unable to secure components together. This can result in...Read more electrical hazards, overheating, instability, and loose connections. Disconnect the wires/cables connected to the old connector and remove it from the housing. Place the new connector in the housing and reconnect the wires to the appropriate terminals, following the guidelines in your equipment manual.

This is an original Toro replacement part. The spring clip is designed by the manufacturer for use in snow throwers. This part is made of metal, and is used in the carburetor assembly to interact with the float and activate the inlet needle. You may require a screwdriver when replacing this item. This part is sold individually.

This is an authentic Briggs & Stratton replacement part. The bearing is commonly found in generators. This part is made of metal, and is used to allow the rotor assembly to spin freely within the stator. You may require a wrench when replacing this part. This item is sold individually.

This is a genuine replacement part that is supplied by the original equipment manufacturer for use with lawn and garden equipment. The o-ring is generally utilized to provide an air-tight seal between connected parts, please refer to the appropriate diagrams of your model for the correct location and application of this hardware. It is a ...Read morehigh-quality component which is made of durable rubber material and is sold individually.

This is an OEM part sourced directly from the manufacturer. The choke positioning spring is commonly found in generators and snowthrowers from Briggs & Stratton and Toro. This part is made of metal, and is used in the carburetor to help hold the choke shaft in position. This part is sold individually.