0879 - Parts

This is a OEM replacement part sourced from the original manufacturer for use with engines made by Briggs & Stratton and Toro. The user will need to replace this screw if it is missing or not working correctly. This part is sold individually and made of metal.

It is a genuine OEM sourced item that is specially produced for use with Briggs and Stratton engines that are commonly installed on Toro lawn and garden equipment. Ignition coil also known as an armature-magneto supplies high voltage electricity to the spark plugs. The primary symptoms usually manifest in the form of extreme difficulty st...Read morearting your equipment, and eventually inability to start it at all. It is a high quality item with a rubber insulated wire and it is sold individually, please note the spark plug boot is sold separately.

Genuine Milwaukee replacement part, this item is sold individually. This is one of the parts that hold the sockets to the anvil on the Impact Wrenches shown below. The other part needed to hold the socket is part number 40-50-8320 Detent Spring.

This is an original replacement part sourced directly from the manufacturer. The alternator is commonly found in engines from Briggs & Stratton, and lawn tractors from Toro. This is a complete alternator assembly, used to convert mechanical energy to electrical energy in the form of alternating current. This part comes with four bolts ...Read moreand four washers for attachment. You may require a screwdriver when replacing these parts.

This is an OEM part sourced directly from the manufacturer. The brush is designed for use in generators from Briggs & Stratton. This part is a complete carbon brush assembly, which is used to supply power to the rotor. You may require a screwdriver or Allen wrench when replacing this part. This item is sold individually.

This connector is sourced from the original manufacturer as a replacement part for use in generators. The connector has 6 pins/terminals which allow the joining of various electrical cables and components in the generator. Over time the connector can break or wear down, rendering it unable to secure components together. This can result in...Read more electrical hazards, overheating, instability, and loose connections. Disconnect the wires/cables connected to the old connector and remove it from the housing. Place the new connector in the housing and reconnect the wires to the appropriate terminals, following the guidelines in your equipment manual.

This is an authentic replacement part sourced directly from the manufacturer. The insulator is commonly found in small engines from Briggs & Stratton. This part is made of a hard fiber composite, and is used to prevent electric current from grounding to components in the engine. This item is sold individually.

This is an original replacement part manufactured for use with small engines. The valve spring provided compression for the exhaust valve to allow the valve to open to expel combustion gases, and to keep it closed when air/fuel is combusted. This valve spring is sold as an individual replacement part.