0879 - Parts

This is a genuine replacement part manufactured for use with small engines. The special wing nut is commonly used to fasten the air cleaner cover and is used with several different model engines. This nut is available as an individual replacement part, please see model diagram for associative parts.

This is an authentic OEM sourced replacement part, it is specially produced for use with Briggs and Stratton engines commonly installed on Toro lawn and garden equipment. This is a standard hardware which has multiple applications based on the model of your unit, please refer to appropriate diagrams for the correct and use of this item. T...Read morehis Torx screw is made of high-quality metal and it is sold individually, it includes one washer.

This washer is a genuine OEM Briggs & Stratton replacement used in small gasoline engines to provide secure fastening, proper spacing, or load distribution between engine components. Made to original factory specifications, it helps maintain correct assembly and reliable operation and is an ideal replacement when a worn, missing, or damaged washer causes looseness, vibration, or improper component fit.

This is an authentic OEM part from Briggs and Stratton and Toro for use with garden equipment engines. The stop wire connects the ignition coil to the stop switch to ground the spark voltage to the engine block when you release the bail control bar. This part is sold individually. The tool that you will need to replace the stop wire is pliers.

Clutch-Drive

This is an authentic OEM sourced replacement piston ring set which is specially produced for Briggs and Stratton engines commonly installed on lawn and garden equipment. The purpose of these parts is to provide a tight seal between the piston and the cylinder walls. A worn or broken piston ring will allow combustion gases to escape the se...Read moreal and enter the crankcase, this would cause low compression and a loss of power. If compression is reduced significantly, the engine will not run at all. Please note this high-quality metal set is sold individually.

It is a genuine item that is supplied by the original equipment manufacturer for use with lawn and garden equipment. This is an identical replacement for a faulty or a missing hardware that was installed on a new unit. To ensure the exact location and the correct application of this screw, refer to the appropriate diagrams for your model....Read more Keep in mind this high-quality screw is made of durable metal and is sold as an individual item. A wrench will be needed to secure or remove it.

This is an authentic replacement part manufactured for use with Briggs & Stratton small engines. The idle mixture kit is used to adjust the amount of fuel that is sent to the engine's intake while the engine is idling. This idle mixture kit is available as an individual replacement part.