074005-0-51CFM Briggs and Stratton Compressor - Parts

This is an authentic OEM authorized part which is designed for use with Briggs and Stratton air compressors. Check valve lets pressurized air flow into the tank and prevents it from flowing back into the pump. Over time it may wear out and begin to malfunction eventually requiring a replacement. When replacing this part make sure to unplu...Read moreg the air compressor and release the air from the tank. It is a high-quality component which is made of durable metal and is sold individually. You would need a wrench to perform this repair. Check the owner's manual and the appropriate diagrams for your model for the correct application.

This is a Genuine Manufacturer Approved replacement part designed to work with Briggs and Stratton Air Compressor. The pressure switch tells your compressor when to stop and when to start. There are multiple reasons a Pressure Switch could be leaking air. If it is leaking air the Pressure Switch should be replaced for a compressor to operate properly and safely.

This is a genuine manufacturer-sourced component which is specially designed for use with Briggs and Stratton air compressors. This breather acts as a valve for the fuel tank, it allows for the air to enter the fuel tank but it won't allow fuel or fuel emissions to leave the tank. Keep in mind it is made of durable material and is sold in...Read moredividually. Please make sure to refer to the owner's manual and the appropriate diagrams for your model for the correct location and application of this component.

140mF +/-5% ; 250V

This is an authentic Briggs & Stratton replacement part, sourced from the original manufacturer for use with air compressors. The plastic fan cover is used to house and protect the end of the motor and the fan assembly. This fan cover is available as an individual replacement part, see part list for associative items.

This is a genuine part that is supplied by the original equipment manufacturer for Briggs and Stratton air compressors. The tank pressure gauge is attached to the manifold to monitor the pressure in the tank. It is an identical replacement for a damaged or a missing part that was installed on a new equipment. Refer to the appropriate diag...Read morerams for your model to ensure the correct repair procedure. A wrench set might be needed to replace this pressure gauge.

This is an original replacement part sourced directly from the manufacturer. The vibration mount kit is found in Briggs & Stratton air compressors. This part is made of rubber, and comes with a metal bolt, a nut, and two washers for attachment. It is used to provide a secure base and reduce vibration in the machine. You will require a wrench when replacing these parts.