0729-21 Milwaukee - Parts

This item is a genuine Milwaukee replacement part and is intended to be used with drills, bandsaws, and shears. The steel bearing is used to reduce friction between a rotating shaft and a fixed part assembly. This bearing's application can vary based on the type of machine you have. It is recommended to check your tool's illustrated diagram to verify the bearing's compatibility. This item is sold individually.

This is a needle bearing that is open on both sides. This is a genuine Milwaukee replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This ...Read morereduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is a genuine manufacturer approved replacement part designed for use with Milwaukee band saws. This is the bumper that the rear blade guide is attached to. It is made out of metal and it is sold individually. Please note the hardware/screws used to attach it are sold separately. To complete this repair you would need a screwdriver.

This is a genuine Milwaukee part sourced directly from the manufacturer for use in band saws. The intermediate gear is made of metal and fits between two different ball bearings. It will need to be replaced if it becomes broken. While replacing this part a screwdriver may be needed. This is available as an individual replacement part.

Genuine Milwaukee replacement part, this item is sold individually. This Front Handle has been used on basically every Bandsaw Milwaukee has manufactured. It is a one piece solid handle. It is mounted to the saw by using screw part number 06-75-4675.

This is a Milwaukee replacement part directly sourced from the manufacturer. The metal worm gear is used in band saws, and fits between the ball bearing and the worm gear shaft. Worm gears change the direction of spinning parts. Over time, gear teeth can become stripped and the gear will need to be replaced. A screwdriver and pliers may be needed to replace this item, which is sold individually.

This is an authentic Milwaukee replacement part, sourced from the original manufacturer for use with band saws. The special sprocket is used to link the drive belt and the blade pulley. This sprocket is available as an individual replacement part, please see model diagram for associative parts.

Included in part number 14-13-0210