06-44SC01 (1990) Toro Snow Blower - Parts

This is an authentic OEM self-tapping bolt used on Toro snow throwers/blowers. It is designed to secure the bushing/gear case assembly together. By using a wrench and a self tapping bolt, precisely fitted threads are created in the opening of the case. This allows for the two part to be secured tightly together. Please note this bolt is sold individually.

The Ni Lock Nut (Nylock Nut) is a Silver, 5/16x18, individually sold metal nut. It can be adjusted and replaced using a wrench or socket and torque wrench to the manufacturer specfications, and is used to secure the sheer pin in place on the augur. These nuts are a one time use part due to their locking mechanism. You'll know the nut has...Read more broken because the augur will not spin, and this is when the part should be replaced. Customers found this to be an easy repair.

This rubber oil seal is supplied directly from the original equipment manufacturer for use commonly with snowblowers and a variety of other outdoor power equipment. It can be used to retain gear oil, seal the transmission, and prevent it from leaking out of the engine. The seal keeps the rotating parts adequately lubricated and protects t...Read morehem from friction damage. The seal also prevents dirt and debris from entering and damaging the equipment components. Over time the rubber material may wear down or tear, leading to oil leakage, increased friction, overheating, and damage to the equipment. To replace the seal, first drain the oil and use a seal puller or flat screwdriver to remove the old seal. Clean the area thoroughly to ensure a good fit for the new seal and add a thin layer of oil around the seal. Align the new seal on the mounting surface and use a seal driver or socket to press the seal down until it is secure. Remember to refill your oil before starting your equipment again.

This item has been sourced from the original manufacturer and is intended to be used with snowthrowers from Toro. The metal woodruff key is used to link the motor drive shaft and the impeller pulley to allow the shaft to rotate the pulley. This woodruff key is priced as a single item.

This is a genuine Toro replacement part that has been sourced from the original manufacturer to be used with snowthrowers. The gasket is used to provide spacing between the two halves of the auger's gearcase assembly. It is recommended to replace gaskets when servicing the gearcase to ensure proper seals when the parts are reassembled. This item is sold individually.

This is a genuine manufacturer-supplied part that is made for Toro and Lawn-Boy lawn and garden equipment. Bushings are commonly utilized to provide a tight fit between connected components allowing them to rotate with minimum friction. Over time the material will wear out and it may begin to fail eventually requiring a replacement. This ...Read morehigh-quality bushing is made of durable material and is sold individually. Refer to the parts diagrams for your model to ensure the correct repair procedure.

This authentic OEM sourced part is specially designed for use with Toro snowthrowers. Ball bearings are generally utilized to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. Unfortunately, over time the componen...Read morets will wear out and may begin to fail eventually requiring a replacement. Keep in mind this high-quality bearing is made of durable metal and is sold individually.

This is an OEM part sourced directly from the manufacturer. The flange bearing is commonly found in Toro snow throwers. This part is made of metal, and is generally used in securing the auger assembly. You may require a wrench when replacing this item. This product is available as an individual replacement part.

This is a genuine Toro replacement part. The thrust washer is designed by the manufacturer for use in snow throwers. This part is made of metal, and is generally used in securing the impeller shaft. Please be aware that there are different washers used in the machine. Refer to the parts diagram to be sure of ordering the correct part....Read more You may require a screwdriver when replacing this item. This part is sold individually.