My Orders
- Home
- 048231018036
- Instructions
048231018036 (ALBEEUS) LG Washer Dryer Combo - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Dishwasher was noisy. PartsDirect suggested replacing circ pump.
7 of 8 people
found this instruction helpful.
-
Doug from NEWPORT NEWS, VA
- Difficult
- More than 2 hours
-
Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
Relocated dishwasher to garage and set it up on a table (easier on back having it elevated). Connected temporary water supply, drained to a bucket.
Removed pump, and found it severely corroded, indicating leakage from pump shaft seal in sump. Inspection of seal revealed excessive wear, requiring sump replacement (there is no wa ... Read more y to replace just the pump seal). I have photos of old pump & sump, but I don't see any way to upload them.
Removed sump from dishwasher with all components attached, swapped components over to new sump, reinstalled sump (with new sump gasket) and started dishwasher to check for leaks. The heater was the most difficult component to swap. Reinstalling the sump assembly was tricky.
Reinstalled dishwasher into kitchen cabinet.
Removed pump, and found it severely corroded, indicating leakage from pump shaft seal in sump. Inspection of seal revealed excessive wear, requiring sump replacement (there is no wa ... Read more y to replace just the pump seal). I have photos of old pump & sump, but I don't see any way to upload them.
Removed sump from dishwasher with all components attached, swapped components over to new sump, reinstalled sump (with new sump gasket) and started dishwasher to check for leaks. The heater was the most difficult component to swap. Reinstalling the sump assembly was tricky.
Reinstalled dishwasher into kitchen cabinet.
Read less
Was this helpful?
Thank you for voting!
Dish washer would shut off mid cycle.
-
Richard from Camdenton, MO
- A Bit Difficult
- 30 - 60 mins
-
Screw drivers
Check the motor and discovered roughness when you turned the shaft. I assume there was a bearing problem. I ordered a new motor from part select and upon the replacement washer is working great! Thanks part select, my part arrived in a timely manner and you guys saved me approx. $500. Thanx again. Richard Sansom
Was this helpful?
Thank you for voting!