04024 - Parts

This is an authentic Toro replacement part, sourced from the original manufacturer for use with snowthrowers. The metal washer is commonly used to disperse pressure put on the auger housing by the nut that fastens the chute retainer across a wider surface area. This bolt is sold individually.

This genuine OEM oil filter helps to remove harmful contaminants from engine oil. It is sold Individually. Used on select Intek and Vanguard OHV engines. This part maintains optimum performance of your engine in accordance with applicable EPA emissions regulations. It is recommended to replace an Oil Filter at least once a season.

Screw hex 1/4-20x.5

This connector is sourced from the original manufacturer as a replacement part for use in generators. The connector has 6 pins/terminals which allow the joining of various electrical cables and components in the generator. Over time the connector can break or wear down, rendering it unable to secure components together. This can result in...Read more electrical hazards, overheating, instability, and loose connections. Disconnect the wires/cables connected to the old connector and remove it from the housing. Place the new connector in the housing and reconnect the wires to the appropriate terminals, following the guidelines in your equipment manual.

This is an authentic Briggs & Stratton replacement part. The bearing is commonly found in generators. This part is made of metal, and is used to allow the rotor assembly to spin freely within the stator. You may require a wrench when replacing this part. This item is sold individually.

This is an OEM part sourced directly from the manufacturer. The bearing carrier is commonly found in generators from Briggs & Stratton and Snapper. This part is made of metal, and is used to hold one end of the stator assembly and the brush holder. You will require a wrench when replacing this item. This product is sold with a flexible rubber O-ring.

The bearing-caged needle roller goes between the pivot arm and the thrust washer. This part is available individually and is made of metal. It is a genuine OEM sourced part which is specially designed for use with Toro and Lawn Boy lawn mowers. During replacement, it may require a set of pliers to help install this part correctly. It will need to be replaced if it becomes broken.