030247-01 Troy-Bilt Generator - Parts

Voltage Regulator

★★★★★

★★★★★

(3)

The OEM voltage regulator or voltage control is a part used to regulate the voltage so it can provide the right amount of power to electrical components. It attaches inside the alternator housing. The... Add to cart

E-ring The OEM E-Ring is a silver metal part used to secure the wheel on the shaft. If broken, the wheel may fall off, and the part must be replaced. It is rated as "Easy" to install and requires pliers and a screw driver. Add to cart

Battery

★★★★★

★★★★★

(1)

This Battery supplies power to a generator's electrical systems. It attaches inside the battery housing, which is usually mounted to the frame. It can be installed using a wrench set, and its installa... Add to cart

18oz 30w 4 Cycle Oil This bottle of oil can be used in over 150 different types of machinery. It is most commonly used for pressure washers and generators from manufacturers such as Briggs and Stratton and Troy-Bilt. This... Add to cart

Wheel The authentic 10" Wheel Assembly (Wheel, 10" Diameter) is a 10-inch black, plastic-and-ubber wheel. It allows easy moving of the generator. Installation requires pliers and is rated as "Easy". If your... Add to cart

Cover, Rbc Plastic With Cap This rear bearing cover is designed to protect and insulate the rear bearing of the engine. It is an authentic OEM replacement part with a diameter of approximately 8 inches. It comes with a center/du... Add to cart

Mount, Vibration The OEM vibration mount is a black rubber part, which is used to prevent vibrations between the frame of the generator and the floor. It can be installed with a screw driver,and its installation is ra... Add to cart

Assembly, Support

Screw, M5 - .8 X 10 Taptite This is an original Briggs & Stratton replacement part. The screw is designed by the manufacturer for use in generators. This part is made of metal, and is generally used in securing the bearing cov... Add to cart

Nut, M8 Flange Serrated The manufacturer certified M8 Flange Nut is an 8mm silver, serrated, metal part. It can be installed using a wrench or socket, and is used to secure parts in place and secure the load. If broken or da... Add to cart

Assembly, Fold Down Handle The authentic fold down handle attaches onto the frame and allows you to pick up and more easily maneuver equipment. This assembly contains everything you will need to replace the entire handle. It ca... Add to cart

Kit, Battery Hardware Add to cart