0301 - Parts

This item is available as an individual replacement part and is made of metal. The armature service goes between the ball bearing and the fan assembly. A screwdriver and a bearing puller might be necessary during the installation of this part. Over time this item may break and will need to be replaced. This is a genuine replacement part s...Read moreourced from the original manufacturer for use with drills and shears made by Milwaukee.

Genuine manufacturer approved replacement part designed for use with Milwaukee power tools. This assembly holds carbon brushes around the armature to provide stable and safe contact. This assembly consists of: plastic holder ring, two (2) metal brush holders with springs and two (2) carbon brushes with lead wires attached. To replace thi...Read mores assembly you would need a screwdriver. • First remove screws holding the housing together • Carefully separate housing to gain access to armature and brush holder • Disconnect the wires • Remove the screws holding brush card assembly • Remove old brush holder and install the new assembly • Reassemble and test your tool

This is an authentic Milwaukee replacement part, sourced from the original manufacturer for use with electric drill/drivers. The metal nut is commonly used to secure the end of the side handle assembly. This square nut is available as an individual replacement part, please see illustrated diagram for associative parts.

This Chuck Key Holder securely attaches chuck key 48-66-3280, 48-66-2110, 48-66-3480, 48-66-3080 or 48-66-3240 to the cordset of your drill which has chuck 48-66-0240, 48-66-0795, 48-66-0797, 48-66-0805, 48-66-1360, 48-66-5185, 48-66-1381 or 48-66-2100 on it.

This is a genuine replacement part designed for Milwaukee Electric drills/drivers. It is supplied directly from original equipment manufacturer and it is sold individually. This is the side handle that provides a safe and stable grip for your tool. It is made out of plastic and metal. To replace this side handle no tools would be needed....Read more • Turn the side handle counterclockwise to loosen • Slide the side handle assembly forward over the chuck and rotate to the desired angle • Slide the side handle back to the gearcase and position the locking keys into the detents • The locking keys help prevent the handle from slipping • Turn the side handle clockwise to tighten

This is an authentic Milwaukee replacement part, sourced from the original manufacturer for use with electric drill/drivers. The special intermediate shaft is used to drive the intermediate gear. This intermediate shaft is available as an individual replacement part, please see model diagram for associative parts.

It is a genuine manufacturer-approved replacement gasket which is specially designed for use with Milwaukee power tools. This high-quality gasket provides an air-tight seal for the gearcase. Over time gaskets tend to deteriorate and crack eventually requiring replacement to maintain the proper seal. It is made of durable composite material and it is sold individually.

The side handle attaches to the side handle clamp and is made of plastic. It is an authentic OEM sourced item which is specifically produced for use with Milwaukee electric drills. This item is available as an individual replacement part. A wrench may be helpful when replacing this item. This part may become broken and will need to be replaced.

The brush spring goes next to the brush assembly. It is a genuine Milwaukee replacement part for use in drywall screwdrivers, screwguns, drills, and drivers. This item is available individually and is made out of metal. If this part becomes broken it will need to be replaced and may require a set of pliers and a screwdriver during the installation.

Genuine manufacturer approved replacement switch used with Milwaukee power tools. It responsible for handling on/off function of the unit. Since switches have mechanical parts, they will eventually wear out and will need to be replaced. This switch has a plastic body and it is sold individually. To replace this switch you would need a to...Read morerx screwdriver. • Remove screws that hold two pieces of the housing together • Disconnect wires from the old switch and remove it from the housing • Place the new switch in the housing and connect wires to it • Reassemble and test the tool