My Orders
02049 Pressure Washer - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
The copper fitting on the chemical injection broke.
12 of 17 people
found this instruction helpful.
-
Carl from ARCADIA, FL
- Very Easy
- 30 - 60 mins
-
Nutdriver, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
I order the part from this site and received it within a week. the only problem was that spring was missing out of the sealed bag. NO PROBLEM!!! I cut a ball point pen spring to fit and everything works just fine. You just have to remember to put the spring in first, then the ball bearing and then the rubber o-ring.If you put them in back
... Read more
wards you pressure will fed directly into your chemical container!!
Read less
Was this helpful?
Thank you for voting!
Factory Manifold plug eroded and broke loose
1 person
found this instruction helpful.
-
Greg from NEW KENSINGTN, PA
- Very Easy
- Less than 15 mins
-
Wrench set
Using a flat head screw driver remove what's remaining of the old plug. Install the new plug, making sure you do not tilt the machine too much or it will size up.
Was this helpful?
Thank you for voting!
Generator would not start, Birggs & Stratton recommended to replase Gasket Exhaust.
11 of 45 people
found this instruction helpful.
-
Alberto from PALMETTO BAY, FL
- Really Easy
- 30 - 60 mins
-
Socket set
Remove the spark suppresser, 4 face screws, 2 bottom screws and the two screws the hold the gasket. I also had to back out the top screw of the cover it blocked and prevented the removal of the gasket.
Was this helpful?
Thank you for voting!