02045 Pressure Washer - Parts

This is an authentic OEM sourced nozzle kit which is designed for use with Troy-Bilt and Briggs and Stratton pressure washers. The nozzles are designed to be attached to the spray wand to produce a fine spray pattern. Over time parts will wear out and they may begin to fail eventually requiring replacements. Keep in mind this high-quality...Read more kit includes four nozzles. Refer to the owner's manual for your model to ensure the correct application of these parts.

This is an authentic OEM part designed to fit the pressure washers listed below. This is a yellow chiseling style tip, with a standard fifteen (15) degree spray width. This nozzle is recommended for water only. It is ideal for heavy duty pressure washing of harder surfaces and stubborn stains/grime. This is a very commonly used nozzle so a backup could be handy. Sold individually.

This is an authentic OEM sourced replacement part that is intended to be used with pressure washers from Troy-Bilt and Briggs & Stratton. The red nozzle is 0-¦ and attaches to the end of the spray wand. This nozzle emits a small concentrated stream of water. The red nozzle is used to remove tough stains in concrete and metal. It is advise...Read mored to not use this nozzle on wood or siding because this nozzle produces a powerful stream that can damage soft materials. The red nozzle is sold as an individual replacement part.

This part is a genuine replacement wand for use with Troy-Bilt, Snapper and Briggs and Stratton pressure washers. It is an identical replacement for a faulty or a missing part that was included with a new unit. One reason you would need to replace the extension is that the threads on the couplings can strip out over time. Another common p...Read moreroblem is freeze damage to the fittings. If liquid is left in the sprayer during the winter it can freeze. The frozen liquid will expand, causing the fittings to split and then leak. Keep in mind this high-quality extension is sold as an individual item. Refer to the owner's manual for your equipment to ensure the proper application.

This is sold as a kit and will need to be replaced if it becomes broken. The unloader kit is made out of metal and helps to control the water pressure. It is a genuine Briggs & Stratton and Troy-Bilt part sourced directly from the manufacturer for use in pressure washers. When replacing this item, a wrench and a set of pliers might be required during the installation process.

This is an authentic replacement part that has been sourced from the original manufacturer to be used with small engines from Snapper, Briggs & Stratton, and Troy-Bilt. The metal square key is used to link a rotating shaft and a pulley or gear. The key will fit in the slot on the shaft and align with the keyway on the pulley or gear, this...Read more will allow the two part to rotate in unison. The key is used with several different engines and the application of the key can vary based on the model. This key is sold as an individual replacement part.