02021 Pressure Washer - Instructions

I order the part from this site and received it within a week. the only problem was that spring was missing out of the sealed bag. NO PROBLEM!!! I cut a ball point pen spring to fit and everything works just fine. You just have to remember to put the spring in first, then the ball bearing and then the rubber o-ring.If you put them in back ... Read more wards you pressure will fed directly into your chemical container!!

I loosened the rear motor mounts which protrude through slots in the frame using a 15mm open end allowing the engine to be moved enough to pass the front mounts through both the frame and the engine mounting holes. The upper bolts on the front mounts don't have enough clearance for a socket or box end and the open end gets less than a qua ... Read more rter turn at a time unless you remove the wheels. I just took my time and tightened the nuts being careful not to round the corners. The lower bolt/nuts present no problem.

The description of the parts package on your website did not appear to be in proper (size) scale However, after following a Youtube video, I was then able to decipher what parts went where to be sure I was ordering the correct parts that I needed. Parts were shipped promptly and I found that replacing just the check valve o rings and sea ... Read more ts, it cured the problem without having to use the other parts that came with the kit package. Would definitely order from this site again. BL NC