0154 Briggs and Stratton Pressure Washer - Parts

The authentic 10" Wheel Assembly (Wheel, 10" Diameter) is a 10-inch black, plastic-and-ubber wheel. It allows easy moving of the generator. Installation requires pliers and is rated as "Easy". If your tire is flat, then it should be replaced. Refer to your make, model and diagram to ensure this is the right part.

This item has been OEM sourced to ensure quality. The clear plastic hose is intended to be used with pressure washers from Troy-Bilt and Briggs & Stratton. This part includes the fittings at the ends. The hose is used to carry chemicals or soap from the detergent tank to the pump when using the machine to clean. This item is available as an individual replacement part.

This is an authentic Murray replacement part that has been sourced from the original manufacturer to be used with riding lawnmowers. The metal washer is used to provide spacing between the steering spindle and the front axle assembly. This item is sold individually, please note two washers may be needed.

This is an authentic Briggs & Stratton replacement part manufactured for use with pressure washers. The seals are used with the brass head on the pump. This seal set kit is sold as an individual replacement part.

It is an authentic manufacturer-supplied check valves kit which is designed for use with Briggs and Stratton, Snapper and Troy-Bilt pressure washers. The check valves are important components that attach to the pump head to help maintain safe working water pressure in the pump. Unfortunately, over time they may wear out or get damaged eve...Read morentually requiring replacements. It is a high-quality kit which includes six check valve, the O-rings, and the hardware to secure them. Make sure to refer to the appropriate diagrams and the owner's manual for your model to ensure the correct replacement procedure. An Allen wrench set will be needed to take apart and reassemble the pump housing when replacing these components.

This is a genuine Briggs & Stratton replacement part. The oil seal is designed by the manufacturer for use in pressure washers. This part is placed in the crankcase to prevent inadvertent oil leakage. You may require a screwdriver or Allen wrench when replacing this item. This part is sold individually.

This is an authentic OEM part for use with Craftsman Pressure Washers. The wand connects to the spray gun handle and houses the nozzle that directs the spray stream. The most common reasons for replacing the spray wand are when it is worn-out or is leaking. This part is sold individually. The tool that you will need to replace the wand is a 5/8 inch wrench. Shut the pressure washer off before installing the wand.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton generators and pressure washers. The purpose of this component is to reduce the vibration of a working unit, unfortunately, over time it may begin to fail eventually requiring a replacement. Please make sure to refer to...Read more the appropriate diagrams of your model for the correct location and application of this part. Keep in mind this high-quality vibe mount with a washer is sold individually.