Metabo Jig Saw Parts

This is a genuine manufacturer-supplied replacement which is specially designed for use with Metabo power tools. The purpose of a brush is to conduct the crurrent in an electric motor that powers the tool. Unfortunately, the material will wear out and it may cause intermittent performance eventually requiring a replacement. Keep in mind this high-quality brush is sold in a pack of two. When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem. Please refer to the appropriate diagrams and the owners manual for the exact location and installation of these components. Not sure if your carbon brush is causing your motor problems? See our power tool repair article: <a href="http://www.ereplacementparts.com/whodunnit-the-brushes-the-switch-c-8873_8875.html" target=blank><u>Whodunnit? The brushes or the switch?</u></a>

This item is a genuine Metabo replacement part that has been OEM sourced and is intended to be used with angle grinders. The carbon brush is used to relay electricity from the switch to the motor assembly. The brush is pressed against the commutator bars while the armature is spinning and this can cause the brush to wear down over time and will need to be replaced. This item is a complete part assembly that includes the brush holder, spring, and one brush. This item is sold as an individual replacement part.

This replacement slider switch knob is a genuine metabo part. It is supplied directly from manufacturer for use with grinders/polishers. It is the slider knob for the main on/off switch of a tool. This slider is made out of black plastic and it is sold individually. Replacing this switch slider should only require a screwdriver. • Make sure the tool is unplugged • Remove the housing screws • Remove the slider and secure the new one in place • Reassemble and test the unit

This high quality replacement switch is used on Metabo power tools. It is an authentic OEM sourced item, not an aftermarket imitation. It is the mechanical switch that allows user to turn the tool on and off. Since switches have moving plastic parts, they will eventually wear out and fail requiring a replacement. Please note, one switch is included per order. To complete this repair you will need a screwdriver. • Remove the housing • Disconnect wires from the old switch • Remove the old switch • Secure the new switch in place • Connect wires to it • Reassemble and test the tool

This is an authentic replacement part manufactured for Metabo electric power tools. The special switch is used to relay electricity from the power cord to the motor assembly and is used with a variety of different power tools. This special switch is available as an individual replacement part, please see tool model's part list for compatibility.

This is an authentic OEM part which is designed for use with Metabo power tools. It is a special component which helps to secure the lever. This is a high-quality replacement for a damaged or a faulty hardware that was installed on a new unit. Check the appropriate diagrams for your specific model for the exact location and the correct application. You will need a screwdriver and pliers to perform the repair. One durable metal circlip is included.

This is a genuine part which is supplied directly by the original equipment manufacturer and is used with Metabo power tools. The cable sleeve fits through the opening in the housing where the power cord is wired, it will protect the base of the cord from getting bent or pinched. This part is made of rubber and is sold individually. For installation, you will need a screwdriver and a pair of needle nose pliers to aid you.