Max Nailer Parts

This is an authentic replacement part manufactured for use with Max pneumatic stick nailers. The cylinder seal is used to seal the connection between the top of the cylinder and the cylinder valve. This cylinder seal is available as an individual replacement part, please see model diagram for associative parts.

This replacement bumper is a genuine manufacturer sourced item used with Max roofing coil nailers. The purpose of the bumper is to prevent piston from hitting the bottom of the cylinder and damaging it. Because it gets so much abuse over time it may crack and fall apart eventually requiring replacement. This bumper is made from durable high quality plastic material and it is sold individually.

It is an authentic manufacturer-sourced part which is specially designed for use with Max nailers. This part acts as a cushion when the piston retracts back into the cylinder after being fired. Unfortunately, over time the material will wear out and it may begin to fail eventually requiring a replacement. Keep in mind this high-quality item is made of durable rubber and is sold individually.

This is an authentic Max item that is supplied by the original manufacturer for use with nailers. The compression spring is utilized to apply tension on the connected parts. Over time hardware can wear out and stretch eventually requiring a replacement. Please note this high-quality compression spring is made of durable metal and is sold individually. Refer to the appropriate diagrams for your model when replacing this component.

This genuine manufacturer-sourced part is specially designed for Max nailers. It is an important component which provides a tight seal between connected components. Unfortunately, over time it will wear out and it may begin to crack eventually requiring a replacement. To ensure the correct repair procedure, refer to the appropriate diagrams for your model. Note, this high-quality O-ring is made of durable rubber material and is sold as an individual item. A screwdriver will be needed to take apart and reassemble the tool when performing this repair.

It is an authentic item that is supplied directly from the original equipment manufacturer for Max nailers. The purpose of this component is to provide an air-tight seal for the cylinder cap, unfortunately, over time the material will wear out and it may begin to crack eventually requiring a replacement. Make sure to check the appropriate diagram of your model for the exact location and application of this part. Keep in mind the seal is made of durable composite materials and is sold individually.

This is an authentic manufacturer-sourced replacement cylinder seal which is specially made for use with Max nailers and staplers. The purpose of this item is to provide a tight seal between connected components, please make sure to check the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality item is made of durable rubber material and is sold individually.

This part is an OEM from the MAX manufacturer. The rubber washer 7 is compatible with many nailer devices. This item often secures the step pin in the feed pawl. It is recommended to refer to specific manual and diagrams for repair instruction. The rubber washer 7 is sold individually. A hex key and a wrench are helpful in making the replacement.

It is an OEM item which is made for Max stick nailers. This component provides an air-tight seal for the cylinder cap. Over time the material will wear out and it may begin to crack eventually requiring a replacement to prevent air leaks. To ensure the correct installation of the new seal, refer to the specific diagrams of your model. Note, it is made of durable material and is sold as an individual component. You will need an Allen wrench to remove and resecure the cylinder cap hardware in order to perform this repair.